Here the simple Mini UPS circuit diagram. This circuit can provide an uninterrupted power supply (UPS) to operate 12V, 9V and 5V DC-powered instruments at up to 1A current. The backup battery will take up the load with no spikes or delay when the mains electrical power gets interrupted. It could possibly also be utilized… Read More »
This is the schematic diagram of solar powered mobile phone battery charger. The circuit is designed to charge the battery from a source with a lower voltage. Do not use it to charge the battery with the same or lower voltage than the voltage which is generated by the solar panel. For proper operation of… Read More »
This is the circuit diagram of 5V Regulated Power Supply circuit, featured with over voltage protection. The circuit is based regulator chip 7805; Thyristor SCR 2N1595 and Dioda Zener 1N3997 for overvoltage protection circuit. The 5V regulated power supply is apply 74LS series integrated circuits which has to be really precise and tolerant of voltage… Read More »
This circuit is basically a 8W inverter circuit. The circuit continues to be intended to drive an 8W fluorescent lamp from a 12V power supply, utilizing an cheap inverter primarily based on a ZTX652 transistor. The inverter will operate from supplies in the variety of 10V to 16.5V, obtaining efficiencies up to 78% as a… Read More »
This is the circuit diagram of DC to DC converter based LM2596, the circuit has a single input supply and multiple voltage outputs. The circuit has an input voltage range of 15V to 40V. It has 5 outputs: 3.3V at 1.5A; +12V and −12V at 50 mA each; and +5V and −5V at 50 mA… Read More »
1000W Power Inverter circuit diagram: This is the power inverter circuit based MOSFET RFP50N06. The inverter capable to handle loads up to 1000W, it’s depended on your power inverter transformer. The RFP50N06 Fets are rated at 50 Amps and 60 Volts. Heatsink is required for cooling the MOSFETs. You may add some MOSFETs with parallel… Read More »
This is the fixed 5V to 12V DC to DC converter. The circuit application converts input voltage of 5V (range 4.5V-5.5v) to 12V fixed regulated DC output. The circuit built based National regulator monolithic IC LM2586 which is specifically designed for flyback, step-up (boost), and forward converter circuit applications. The LM2586 will require a heat… Read More »
Powered with solar panel, the circuit will give you 5V pure regulated DC voltage. This solar cell power supply circuit is made up of an oscillator transistor as well as a regulator transistor. The solar panel charges the battery when sunlight is bright enough to generate a voltage above 1.9v. A diode is necessary between… Read More »
This circuit generates 3 source regulated voltages applying a minimum of electronic parts. The output DC voltage are +12V ; +5V and -5V. Diodes D2 and D3 conduct full-wave rectification, at the same time charging capacitor C2 on each halves of the alternating current cycle. At the same time, diode D1 with capacitor C1, and… Read More »