This is the circuit diagram of mini FM receiver that build based on single FM IC TDA7012T.
Components List:
R1 = 8kΩ2 R2 = 10kΩ R3 = 390Ω C1,C3 = 10nF C2,C6,C9,C16 = 100nF C4 = 33pF C5 = 25pF trimmer (Murata type TZB4Z250AB10R00) C7,C10 = 1nF5 C8 = 820pF | C11 = 1nF C12 = 68pF C13 = 220pF C14 = 47uF 10V (Nichicon UWX1A470MCL1GB 5.5mmL chip type) C15 = 3nF3 L1 = 36nH (4 turns 0.5mm silver-plated wire, inside diameter 4mm; length 7mm) L2 = 1uH, SMD case 0805 (fres > 300 MHz) IC1 = TDA7021T (SMD in SO16 case) |
The TDA7021T integrated radio receiver circuit is for portable radios, stereo as well as mono, where a minimum of periphery is important in terms of small dimensions and low cost. It is fully compatible for applications using the low-voltage micro tuning system (MTS). The IC has a frequency locked loop (FLL) system with an intermediate frequency of 76 kHz. The selectivity is obtained by active RC filters. The only function to be tuned is the resonant frequency of the oscillator. Interstation noise as well as noise from receiving weak signals is reduced by a correlation mute system.
PCB Layout:
This receiver is a mono implementation, but at the output, the entire multiplexed signal (up to 53 kHz) is available. By using a PLL stereo decoder, such as the TDA7040T, a stereo signal can be generated in a traightforward way from the output signal of the TDA7021T.
Download the TDA7021T datasheet include the schematic diagram how to make this circuit stereo.
[wpdm_file id=55]
FM Receiver with TDA7021T source: http://electroniccircuit-s.blogspot.com/2009/07/mini-fm-receiver-circuit.html
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
thanks