The following is an electronic circuit called galaxy audio booster which serves to improve the performance of your audio system. This circuit uses an IC RC4558 in which there are two op-amp modules that can be used for stereo audio applications.
The circuit is similar to stereo tone booster that uses the principle of High Pass Filters are then amplified to produce a powerful high tone; and also uses the principle of Low Pass Filter which is then amplified to produce a powerful low tone.
Regulated DC power supply 12-15V should be used to make this circuit work with the maximum performance and reduce “hum” noise.
RC4558 Op-Amps Description
The RC4558 device is a dual general-purpose operational amplifier, with each half electrically similar to the ÂuA741, except that offset null capability is not provided.
The high common-mode input voltage range and the absence of latch-up make this amplifier ideal for voltage-follower applications. The device is short-circuit protected, and the internal frequency compensation ensures stability without external components.
RC4558 Features:
- Continuous Short-Circuit Protection
- Wide Common-Mode and Differential Voltage Ranges
- No Frequency Compensation Required
- Low Power Consumption
- No Latch-Up
- Unity-Gain Bandwidth: 3 MHz Typ
- Gain and Phase Match Between Amplifiers
- Low Noise: 8 nV/√Hz Typ at 1 kHz
APPLICATIONS
- DVD Recorders and Players
- Pro Audio Mixers
Download datasheet document: RC4558 Datasheet
Source: circuitschematicelectronics.blogspot.co.id
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
