This is a inexpensive high fidelity (hi-fi) tone control circuit designed just with two low cost transistors as the active components. The schematic is one channel (mono) tone control, build the similar circuit will make it become stereo channel.
This Hi-Fi tone control circuit can be operated with wide range supply voltage, 12V – 24V DC. Three potensiometers used for sound adjustment: volume level, bass and treble level.
Use good components (such as metalfilm resistors, MKM capacitors, tantalum capacitors, good cable quality) and stabilized/regulated power supply for better sound quality output, of course it will be need more cost. 🙂
The quality of components, cabling and power supply will affect the quality of the output.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…