Categories: AudioPre Amplifier

HiFi Audio Pre-amp

This is a HiFi pre-amplifier circuit diagram with low noise output. Very wide range frequency from about 10Hz until up to 100Khz  will be gained by this preamplifier for maximum audio performance. This circuit uses BC550C / BC560C transistors as active component. Use regulated power supply 15VDC for maximum result.


Here the response of the preamp’s frequency and phase:

Here the diagram of total noise at output, measured with 600R load:

circuit by Graham Maynard

circuit diagram

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago