Here is the USB sound card circuit based on PCM2706 which dedicated for USB audio. With USB controller module inside PCM2706, there is no more additional programming to the IC. The computer system will automatically detect this circuit when connected to the USB port. You will get stereo audio channel output from this circuit.
Schematic Diagram:
Components List:
| 1x PCM2706 – 32-PIN TQFP 1x 12 MHz Crystal 1x 1M Resistor 4x 3.3K Resistor 2x 1.5K Resistor 2x 22 Ohm Resistor | 2x 15 Ohm Resistor 2x 100uF Capacitor 2x 47uF Capacitor 4x 1uF Capacitor 2x 22nF Capacitor 2x 27pF Capacitor |
PCB Layout:
The PCB layout using double layer design. You may create your own design using single layer board, but it will be resulting larger size of PCB.
Technical Specifications:
Source: http://electronics-diy.com/PCM2706_USB_Soundcard.php
Visit the page for more detail of PCM2706 USB Sound Card circuit explanation.
About PCM2706:
The PCM2704/5/6/7 is TI”s single-chip USB stereo audio DAC with USB 1.1 compliant full-speed protocol controller and S/PDIF. The USB-protocol controller works with no software code, but USB descriptors can be modified in some parts (for example, vendor ID/product ID) through the use of an external ROM (PCM2704/6) SPI (PCM2705/7) or on request. The PCM2704/5/6/7 employs SpAct architecture, TI”s unique system that recovers the audio clock from USB packet data. On-chip analog PLLs with SpAct enable playback with low clock jitter.
Download PCM2706 datasheet from the following link:
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
