Power Supply Failure Alarm

This is the ‘special’ circuit design of power supply failure alarm. The vast majority of the power supply failure alarm / indicator circuits require a independent power supply for themselves. However the alarm circuit introduced right here requires no extra supply power source. It utilizes an electrolytic capacitor to hold sufficient charge, to supply power to the alarm circuit which sounds an alarm for a fair duration when the mains supply fails to deliver the electric power.

During the existence of mains power supply, the rectified mains voltage is stepped down to a demanded low level. A zener is applied to restrict the filtered voltage to 15-volt level. Mains existence is recognized by a LED. The low level DC is utilized for charging capacitor C3 and reverse biasing switching transistor T1. Therefore, transistor T1 stays cut-off as long as the mains supply is existing. The moment the mains supply does not work out, the charge saved inside the capacitor works as being a power supply source for transistor T1. Considering that, while in the absence of mains supply, the base of transistor is pulled “low” through resistor R8, it conducts and sounds the buzzer (alarm) to provide an alert of the power failure.

Using the value of C3 as displayed, a high quality buzzer would sound approximately a minute. By increasing or decreasing the value of capacitor C3, this time could be modified for everyone demand.

Constructing the circuit is pretty simple and easy. The values of the parts will not be crucial. When the alarm circuit is operated from any external DC power supply source, the main supply section up to points “P” and “M” can be omitted from the circuit. Following points might be considered:

  1. At a higher DC voltage level, transistor T1 (BC558) may possibly pass some collector-to-emitter loss current, producing a continuous murmuring sound from the buzzer. In that condition, substitute it with some low-gain transistor.
  2. Piezo buzzer has to be a continuous tone version, with built-in oscillator.

To minimize the room space of this power supplu failure alarm, one nicely make use of 5 small sized 1000uF capacitors (arranged in parallel connection) in place of capacitor C3 with bulky high-value .

circuit diagram

View Comments

  • my name is Belachew Ayele,5th year electrical engineering ,at adama university , from Ethiopia ,i am very interested in special power supply failure alarm , & i take it as a model for my graduation research ,i hope you are volunteer,but your design not run in multizem and in other application .therefore i want to ask you if you have an alternative design in this circuit as you attach with my email abiayele@ymail.com

  • my name is Belachew Ayele,5th year electrical engineering ,at adama university , from Ethiopia ,i am very interested in special power supply failure alarm , & i take it as a model for my graduation research ,i hope you are volunteer,but your design not run in multizem and in other application .therefore i want to ask you if you have an alternative design in this circuit as you attach with my email abiayele@ymail.com

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago