This is a 12VDC to 9VDC converter circuit. You may use this DC to DC stepdown converter circuit if you have fixed 12V power supply / battery, but you need 9V power supply for your electronic devices. Scheme Diagram: Components List: R1________ 560 ohm, resistor C1________ 1000uF/16V, Electrolytic capacitor C2________ 100uF/16V, Electrolytic capacitor C3________ 330nF,… Read More »
This is a dual regulated and stabilized power supply, usually used to supply amplifier circuit, it also known as split powersupply. There are 3 output that are (+) voltage, (0) Ground (normal), and (-) voltage. The current output max about 0.3-0.5 A. For higher current output, power transistor is needed. Please take a note that… Read More »
This is another 100 watt inverter circuit diagram. Built based on IC CD4047 and Mosfet IRF540, this inverter have ability to supply electronic device -which require 220VAC- up to 100w from 2-3A transformer from 12V lead acid battery. In the circuit diagram we can observe that 12V battery is connecter to the diode LED and… Read More »
Do you need high current power supply without heavy and expensive transformer? Then, this circuit would be great choice for you. This 13.8 Volt 20 A regulated transformerless power supply. 20A transformer is very-very expensive, large in size and very heavy in weight.
The above diagram is a basic Uninterupted Power Supply (UPS) circuit. This basic UPS circuit is a very simple and inexpensive. This circuit can be adapted/modified for other regulated and unregulated voltages by using different regulators and batteries. For a 15 Volt regulated supply, you may apply two 12V batteries connected in series (it will… Read More »
This is a simple active speaker protector circuit which has a very important use, expecially to protect the loudspeakers of a audio system. It prevent the speaker from noise sound when we turn on the power amplifier. The circuit drives the speakers after 3 to 10 seconds so that the source of the same stabilizes… Read More »
This is the circuit design of unipolar stepper motor driver to control unipolar stepper motors with 5, 6 or 8 wires. It uses four MOSFET IRFZ44. This circuit can be operated in free-standing or PC-controlled mode.
Equaliser circuits typically divide the audio spectrum into separate frequency bands and have independent gain control for each band. The output of each band is mixed at IC4(A) and then fed to an audio power amplifier. Proper quality factor (Q) needs to be selected to avoid overlap in adjacent bands as this introduce colouration into… Read More »
Here is the DIY electronic cardlock security system that can be used as a lock to turn on dan turn off important electronic/electrical appliances. When card is inserted, depending upon the position of punched hole on the card, a particular appliance would be switched on. The card should be rectangular in shape with only one… Read More »