This is the schematic diagram of 400W RMS stereo power amplifier which use power transistor to work. This amplifier in addition to providing good sound power, also with excellent quality and a high fidelity with low noise, to obtain the 400 watts we can put 2 speakers of 4 Ohms or 4 of 8 Ohms.… Read More »
This is the circuit diagram of 70W OCL power amplifier with output power of 70 watts single channel. It uses power transistor TIP2955 and TIP3055 as main component. The power supply used for this amplifier is a symmetrical / dual polarity power supply with output voltage 25V – 32V. This amplifier dan be used to… Read More »
This is the circuit diagram of 2000W class AB power amplifier uses 7 pairs MJ15003 and MJ15004 transistors for the final amplification block. The circuit operated with 90V DC symmetrical (dual polarity) power supply circuit. The transistors must be mounted on heatsink to prevent the overheating, maintain the transistors work in maximum performance.
This is the circuit diagram of 24 Watt class A linear audio amplifier, built and tested by Marc Klynhans from South Africa. The supply voltage can be between 34V and 46V and the quiescent current should be set to 1.7A measured through R25 (a voltage of 0.75V must be measured over R25 for a quiescent… Read More »
Complete manual for Stereo Valve Power Amplifier 2×90 Watt using EL34
This is the circuit diagram of 12 Volts, 4 Amperes Solar Photovoltaic (PV) battery charger which will be suit to charge a 12V battery or accumulator. The circuit handles up to 4 amps of current from a solar panel, which equates to about 75 watts of power. A charging algorithm called “pulse time modulation” is… Read More »
This long-range FM radio transmitter has an additional RF power amplifier stage, after the oscillator stage. The extra RF power amplifier used to strenght up the power output to become 200-250 milliwatts. With a great matching multi-element Yagi antenna or 50-ohm ground—plane antenna, this transmitter can give great good signal strength up to a distance… Read More »
This is a 2W RF amplifier circuit build with single power MOSFET LF2810A. Figure A Figure A is the schematic of the microstrip single stage RF amplifier. The amplifier is based on the M/A-Com LF2810A MOSFET. The transistor is actually a 10 watt, 28 volt part, but provides adequate gain for this application at 12… Read More »
This is the circuit diagram of mic condenser amplifier. The low-cost and compact mic condenser audio amplifier described right here is deliver good-quality audio of 0.5 watts at 4.5 volts. It could possibly be applied as a part of low-power transmitters, packet radio receivers, intercoms and walkie-talkies.