This is a 18 Watt audio amplifier circuit based on power IC HA13118. The supply voltage required for this circuit is 8 – 18V DC, at least 1 to 2 Amps. Maximum output power will only be obtained with a power supply of 18V at greater than 2 A, using a 4 ohm speaker. The… Read More »
This is 1W stereo audio amplifier with LM386N. The output power is 1 watt for each channel, so it should be use two ICs of LM386N National Semiconductor for stereo channel. This circuit belongs to kitsrus.com and the kit is available there or at electronickits.com. This circuit only need 10mA current with best voltage supply… Read More »
This is the circuit diagram of 1W audio amplifier which use TDA7052 as the main component and other 5 pieces of components to support the main component. The ideal supply voltage of this circuit is about 6-12V and no heatsink required. The schematic is for mono audio channel, just build two similar circuit for stereo… Read More »
This 4W Audio Amplifier circuit is powered by 2 pieces of transistor TIP41. The circuit is very simple and incorporates darlington output transistors that will provide more than enough output current than is needed to drive a 3-ohm speaker. The 4W audio amplifier circuit is very simple and incorporates darlington output transistors that will provide… Read More »
Here is the 100W RMS audio amplifier schematic diagram: This circuit is quite simple but will give you high quality audio output. Take a note that above diagram designed for single input and single output (mono system). For stereo system, you need to build two similar circuits.
This is the circuit diagram of 2 Watt mini audio amplifier. This circuit is inexpensive, easy and quite simple. This is general audio amplifier which can be used for computer, CD player or other devices which have headphone output. The circuit was deliberately designed using no ICs and in a rather old-fashioned manner in order… Read More »
This is high fidelity, high quality 25W HiFi audio amplifier circuit delivers great audio performance. You don’t need pre amplifier circuit for this design since it can be directly connected to the input devices such as computers, phones, radios, TVs, etc. Component list: R1,R4 = 47K 1/4W Resistors R2 = 4K7 1/4W Resistors R3 =… Read More »
This long-range FM radio transmitter has an additional RF power amplifier stage, after the oscillator stage. The extra RF power amplifier used to strenght up the power output to become 200-250 milliwatts. With a great matching multi-element Yagi antenna or 50-ohm ground—plane antenna, this transmitter can give great good signal strength up to a distance… Read More »
The following diagram is the schematic diagram fo Car Horn, you may try this circuit for your car modification… 🙂 Components List: R1 = 68K R2 = 2K2 R3 = 56K R4 = 3K3 R5,R6 = 4K7 R7 = 10K Pot/trimpot C1,C2 = 22nF C3,C5 = 100nF C4 = 1nF C6 = 220uF/25V IC1,IC2 =… Read More »