This 6V and 12V car battery charger circuit can be automatically charged, quickly and correctly, 6V and 12V batteries. Circuit design is divided into two series of modules that are: power supply module and the main charger module containing the regulator modules and direct current amplifier module.
Here is the DIY electronic cardlock security system that can be used as a lock to turn on dan turn off important electronic/electrical appliances. When card is inserted, depending upon the position of punched hole on the card, a particular appliance would be switched on. The card should be rectangular in shape with only one… Read More »
This is LED emergency light that will turned on automatically when mains supply fails, and turned off when mains power resumes. This circuit produces highly bright because the use of ultra bright white LEDs. This circuit also has its own battery charger. When the battery is fully charged, the charging process will stop automatically.
Here the simple traffic light controller which is could be used to educate kids rudiments of traffic light guidelines. The circuit utilizes easily available electronic parts. It generally consists of rectifier diodes (1N4001), a 5V regulator 7805, two timers circuit using IC 555, two relays (5V, single-changeover), three 15W, 230V light bulbs and also several… Read More »
This is the 220V / 200W lamp flasher circuit diagram. The frequency/speed of the lamp flashing can be adjust with the range of 1Hz to 5Hz. You can use the PR1 variable resistor (trimpot) to adjust the flashing speed. The duty cycle of lamp flashing can be adjusted using PR2 variable resistor.
The above diagram is the schematic diagram of an electronic motor starter circuit. This motor starter protects singlephase motors against voltage fluctuations and overloading. Its salient function is a soft on/off electronic switch for simple operation. The transformer steps down the AC voltage from 230V to 15V. Diodes D1 and D2 rectify the AC voltage… Read More »
Build based operational amplifier NE5532 and a couple of power transistor TIP41A / TIP42A, this audio amplifier circuit has capability to deliver up to 10W audio power output into 8 ohm speaker.. Amplifier Parts list: P1 22K = Log.Potentiometer P2 = 100K Log.Potentiometer R1 = 820R R2, R4, R8 = 4K7 R3 = 500R Trimpot… Read More »
This is the LED pilot light (or LED indicator) circuit. LEDs (Light Emitting Diode) part are interesting things. They only operate at DC supply within specific tolerances, and generally connected with a current limiting resistor towards the power source. Rather than a resistor, it is possible to use a FET (Field Effect Transistor) like the… Read More »
This simple 220V light dimmer circuit can be used to adjust the brightness of mains lights. It also can be used to adjust the speed of AC motors. It uses a triac, diac and has a radio-frequency interference (RFI) noise suppression circuit built into it as well. Schematic diagram: Components List: R1 = 10K R2… Read More »