The following diagram is the schematic diagram of variable power supply which will deliver 0 to 28V output voltage at 6A or 8A electric current. Components List: R1 = 2K2 Ohm 2,5 Watt R2 = 240 Ohm R3,R4 = 0.1 Ohm 10 Watt R7 = 6K8 Ohm R8 = 10K Ohm R9 = 47 Ohm… Read More »
The following scheme diagram is the battery charger circuit for 6V Gel Cell battery type only. Components List: R1 = 22 ohm, 1W R2 = 270 ohm R3 = 220 ohm *R4 = 715 ohm, 1% *R5 = 3.57K, 1% *R6 = 1.40K, 1% *R7 = 1.47K, 1% C1 = 0.1uF, ceramic C2 = 0.1uF,… Read More »
The following is a circuit of a simple AM transmitter. This circuit is available in kit form and can work well since the kit available on market. This circuit uses a combination of transistors SA101 and SA103, as the modulation signal amplifier.
This circuit is a wireless car alarm system that is built using two circuit modules, namely modules of transmitter and receiver modules. This circuit works on FM radio waves. Car alarms can be used on vehicles that have a 6-12VDC power supply. You can use the voltage stabilizer if your car power supply is too… Read More »
This simple 220V light dimmer circuit can be used to adjust the brightness of mains lights. It also can be used to adjust the speed of AC motors. It uses a triac, diac and has a radio-frequency interference (RFI) noise suppression circuit built into it as well. Schematic diagram: Components List: R1 = 10K R2… Read More »
This is a very simple FM receiver which build based on one transistor only. No chip or another active component. The output is connected to earphones, you need an amplifier circuit if you want to listen the radio with a loudspeaker.
This is the circuit diagram of mini FM receiver that build based on single FM IC TDA7012T. Components List: R1 = 8kΩ2 R2 = 10kΩ R3 = 390Ω C1,C3 = 10nF C2,C6,C9,C16 = 100nF C4 = 33pF C5 = 25pF trimmer (Murata type TZB4Z250AB10R00) C7,C10 = 1nF5 C8 = 820pF C11 = 1nF C12 =… Read More »
This circuit is a powerful three stage, 9V FM transmitter (Tx) with a range of up to 1 kilometer in the open. It uses an RF transistor in its output stage and two BC547″s for the first two stages. Distance of trans-mission is critically dependent on the operating Conditions (in a building or out on… Read More »
If you’re interested in RF circuit, then you should know about this basic RF oscillator. This basic RF oscillator circuit is easy to build and the components are not critical. Most of them can be found in your junk parts box. The circuit operated with 9VDC power supply. The L1 antenna col can be made… Read More »