This is the circuit diagram of power amplifier 45W using power uPC 1230 as the main component. The pre amp head has been added in the circuit using uPC 1032. This is an popular old circuit for hobbysts and the 45 Watt amplifier circuit should be working fine since the PCB already on the market… Read More »
The flasher circuit (Second Circuit) is worked around clock NE555, which is wired as an astable multivibrator that yields square wave at its pin 3. A 10W auto bulb is utilized for flasher. The blazing pace of the bulb is chosen by preset VR1.
This is a basic circuit of car horn and lamp flasher that starts playing the vehicle horn at whatever point your vehicle is backward rigging. The circuit (First Diagram) utilizes double clock NE556 to create the sound. One of the clocks is wired as an astable multivibrator to produce the tone and the other is… Read More »
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are very cheap and easy to find in the electronic market in your area. The circuit has been assembled and tested with very good performance.
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four pieces of power IC TDA7294. It’s mean that every single channel of the circuit uses two ICs in bridge mode. In this application, the load value must not be less than 8 Ohms.
This is a very interesting circuit design to assemble. There are 4in1 amplifier module in a circuit board. 100W power amplifier using the TDA7294, for the VU meter uses IC LM3914. The tone control preamp uses the well-known IC 4558. The symmetrical power supply module also included in the PCB.
This is 120W power amplifier schematic using TO-3 package complementary transistors, NPN and PNP polarity. The well-known power transistor pair of 2N3055 and MJ2955 used in this circuit. +/- 50V symmetrical (split/dual polarity) power supply with minimum 3A electric current should be used for maximum performance.
Here is the circuit diagram and PCB design for relatively low cost DIY bass guitar preamp pedal uses FET K117 or equivalent. There is a bit difficult to build this kind circuit project, it’s require a good knowledge in electronics. This preamp has several features for the bass guitar instrument such as attenuator, low cut, mid… Read More »
This is a 200W power amplifier circuit project. The circuit features high power, good definition and very low noise. It delivers about 200 watts in 4 ohms loudspeaker: a 4 ohm speaker or two pieces of 8 ohm speakers in parallel. This 200W power amplifier using the complementary transistors of 2SC5200 and 2SA1943 as the… Read More »