The following diagram is the FM transmitter circuit with FM transmision up to 4W. Voltage supply for this circuit is 12-16V with current consumption of 100-400mA. This circuit works with frequency of emission range of 88-108MHz. Transistor 2N2219 used as the main signal amplifier. 4 Watts FM Transmitter circuit design: Components List: R1, R2 =… Read More »
The following diagram is the schematic diagram of 4 transistors FM transmitter circuit designed by Paul K. Sherby. Components List: R1,R2,R8 = 1K R3 = 100K R4 = 150K R5,R7 = 10K R6 = 220 ohm R9 = 10 ohm P1 = 5K trimpot D1 = 1N4002 Q1,Q2 = 2N3904 Q3,Q4 = 7001, NTE123AP C1… Read More »
In the above circuit diagram, a CMOS operational amplifier (op-amp) controls the current via a P-Channel HEXFET power transistor (IRF9520) to maintain a constant voltage across R1. The current is given by: 1 = VREF/R1. The benefits of this configuration are:
This is the positive voltage regulator circuit with PNP Boost transistor: The IC8211 presents the voltage reference and regulator amplifier, while Q1 will be the series pass transistor. R1 defines the output current of the IC8211, while C1 and C2 present loop stability and as well act to suppress feedthrough of input transients to the… Read More »
Here the simple, low cost and easy audio booster circuit. It uses a transistor of 2N3392 ad the main amplifier. Component List: R1 = 47K R2 = 470K R3 = 10K R4 = 560R R5 = 270R C1 = 0.1uF/25v C2 = 3.3uF/25v C3 = 470uF/25V P1 = 100K Q1 = 2N3392 D1 = 5mm.… Read More »
This document contains schematic diagram of Orange 125MK3 including the guitar preamp section, feedback and power amplifier section. Preview:
The following diagram is an inverter circuit which will give you 220V AC 50Hz with maximum power output of 100W. This inverter built using transistors for both the square wave generator module and the amplifier module. Inverter Diagram: The Q1 and Q2 used generate square wave. Q5-Q8 amplify the signal and the transformer to increase… Read More »
A well-known IC LM35 is chosen to be the temperature sensor in this circuit. Output voltage of LM35 will increase by 10mV per degree rise in temperature. Output of LM35 is joined to the non inverting input of the operational amplifier (op-amp) of CA3130. The inverting input of the same op-amp could be provided using the required reference voltage using variable resistor R2.
The following diagram is Mesa Boogie dual rectifier solo head schematic diagram. This is a tubed pre-amp and tubed amplifier designed and manufactured by Mesa Boogie. The following schematic is sample only, download the complete schematic diagram from the links provided in this post. This Mesa Boogie Dual Rectifier available to download in PDF document… Read More »