This is long range FM transmitter with transmision power output is up to 15W. This 15W FM transmitter use power transistor BLY88C as the main transmitter amplifier. Building a good FM transmitter(88-110Mhz) begins with getting a good schematic. You don’t have to understand the precise working of the transmitter to build it. But some basic… Read More »
Circuit Projects Links: Amplifier circuit diagrams – Electronic schematics related to amplifier circuits Power supply circuit diagrams – The colection of power supply circuit diagrams Inverter circuit diagrams – The collection of inverter schematic diagrams Electronics References: Electronic Symbols – The largest collection of electronic symbols on the network Thesis Resources: WriteMyPaperHub –… Read More »
This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram:
This is a mini fm transmitter circuit. I think this is the simplest one. Simple, easy and of course… inexpensive… The supply voltage is between 1.1 – 3 Volts with power consumption is 1.8 mA at 1.5 Volts. This circuit should be able to cover 30 – 50 meters of range max. at 1.5 Volts.… Read More »
This is the circuit diagram of portable mic preamp. This circuit consumes low current supply (about 2mA), so will have a long battery life for supplying the circuit. Harmonic distortion is about 0.1% @ 1V RMS output for all frequencies. Maximum input voltage (level control cursor set at maximum) = 25mV RMS. Maximum input voltage… Read More »
This is a HiFi pre-amplifier circuit diagram with low noise output. Very wide range frequency from about 10Hz until up to 100Khz will be gained by this preamplifier for maximum audio performance. This circuit uses BC550C / BC560C transistors as active component. Use regulated power supply 15VDC for maximum result.
This is a dual regulated and stabilized power supply, usually used to supply amplifier circuit, it also known as split powersupply. There are 3 output that are (+) voltage, (0) Ground (normal), and (-) voltage. The current output max about 0.3-0.5 A. For higher current output, power transistor is needed. Please take a note that… Read More »