This is the electronic circuit diagram of aquarium temperature probe capable to monitor the temperature of water and indicate the rise in temperature through audio-visual indicators. This circuit uses diode 1N34 as the temperature sensing probe. The resistance of the diode will be vary depends on the temperature in its vicinity.
This long-range FM radio transmitter has an additional RF power amplifier stage, after the oscillator stage. The extra RF power amplifier used to strenght up the power output to become 200-250 milliwatts. With a great matching multi-element Yagi antenna or 50-ohm ground—plane antenna, this transmitter can give great good signal strength up to a distance… Read More »
This is the schematic diagram of Infrared (IR) cordless headphone. Maybe it also can be called “wireless headphone”, but it use infrared as sound signal carrier. It use a pair of circuit diagrams that are IR transmitter and IR reveiver. Using this low-cost project one can reproduce audio from TV or other electronic devices without… Read More »
Here is the circuit diagram of stereo digital volume control. This circuit could possibly be applied for upgrading your manual volume management within a stereo amplifier circuit. In this particular circuit, push-to-on switch S1 controls the forward (volume enhance) operation of the two channels while a identical switch S2 controls reverse (volume reduce) operation of… Read More »
Here the simple schematic of multitone siren alarm circuit. This multitone siren is effective for reverse horns, burlgar alarms, and many others. It generates five various audio tones and is much more earcatching than a single-tone siren.
This two chips AM radio receiver circuit is a tuned radio frequency (TRF) receiver of the standard AM (amplitude modulation) radio with broadcast frequencies at 550kHz-600kHz. This is a simple and easy to build AM radio circuit which only using two integrated circuits (IC). This circuit works with 9V voltage supply, you could use 9V… Read More »
Here the simple mixer circuit with 4 inputs and 2 operational amplifier (op-amp) modules: A basic mixer suitable for mixing microphones or even effects outputs. The overall gain from input to output is one if the pot related towards the input is full up. You can make this a net gain of ten (or any… Read More »
The following image is the scheme diagram of six LED stereo VU display circuit which build using Dot/Bar Display Driver IC LM3915. This VU display should be connected before amplifier module circuit. You may connect this circuit at pre-amp output, tone control input/output or equaliser input/output. This circuit powered with 12V DC supply. About LM3915:… Read More »
This is a stereo VU booster circuit diagram based on transistor FCS9014 which usually used for pre-amp and regulator circuit and switching. With simple circuit design, this device could be built easily. Scheme diagram, bottom PCB layout and component placement provided on the following image: This circuit should be connected to audio channel before amplifier… Read More »