This is a 20W Hi-Fi power amplifier circuit build based on single power amplifier IC TDA2040. The single TDA2040 has able to deliver 20W power output. The bridge amplifier which consist of double TDA2040 can deliver 30W power output (8 ohm loudspeaker). About power amplifier IC TDA2040: The TDA2040 is a monolithic integrated circuit in… Read More »
This is a 60W AF power amplifier based on single Sanyo integrated circuit STK-0060II. This circuit delivers 60W mono/single channel audio output. For stereo channel, you may build two identical circuits and of course doubled the power supply current (use 5A transformer for stereo application). The amplifier circuit uses symmetrical (dual polarity) power suppy. Recommended… Read More »
Here the 50W AF power amplifier circuit powered with single IC STK4036II. This circuit will deliver 50W single channel output. The amplifier circuit uses symmetrical (dual polarity) power suppy. Recommended power supply voltage is +/- 35VDC. Use heatsink to prevent overheating on the IC and maximize the STK4036II performance.
This a simple stereo electret microphone pre amplifier circuit. The below design diagram is the design for single channel, but the design of PCB layout is for stereo design og electret mic pre amp. For maximum performance, better quality, use solid capacitors or film capacitors and metal film resistors (1% tolerance). schematic diagram:
This is the circuit diagram of 35W Tube Power Amplifier with EL34. This tube amplifier designed in 1953 and worked from 1954 until 1989. If you’re interested with classic circuit and classic components, then you should try this circuit. The circuit is interesting but i think it is hard to find the tubes. Schematic Diagram:
Here is the 100W RMS audio amplifier schematic diagram: This circuit is quite simple but will give you high quality audio output. Take a note that above diagram designed for single input and single output (mono system). For stereo system, you need to build two similar circuits.
This is 20 watt audio amplifier circuit design which use IC LM1875 as main component. This circuit is simple and very easy to built. For stereo channel, you need to build the two same circuits which will amplify the both of audio channels (right and left channel). Dual polarity / symmetrical power supply required for… Read More »
Equaliser circuits typically divide the audio spectrum into separate frequency bands and have independent gain control for each band. The output of each band is mixed at IC4(A) and then fed to an audio power amplifier. Proper quality factor (Q) needs to be selected to avoid overlap in adjacent bands as this introduce colouration into… Read More »
There are many version of stepper motor type, also the many version of stepper motor controller design. This circuit is a general-purpose stepper motor controller that use IC TDA2030 as the driver. This circuit can be used with a wide range of operating voltages, from approximately 5 V to 18 V. It can drive the… Read More »