The following diagram is the schematic diagram of Ni-CAD battery charger circuit which featured with current and voltage limiting to keep the battery lifetime. The lamp L1 will be light brightly and the LED will be out when the battery is low and battery charging in progress, but the LED is very bright and the… Read More »
The following scheme diagram is the circuit diagram of Lead-Acid battery charger. This circuit provides an initial voltage of 2.5 V per cell at 25 ℃ to quickly charge the battery. The charging current decreases as the battery is charging, and when the current drops to 180 mA, the charging circuit reduces the output voltage… Read More »
The following diagram is the schematic diagram of 12V NiCAD battery charger with charging rate of 200mA/Hour. Components List: Resistor: 1 K Ohm, 68 Ohm, 2 K Ohm, Potensiometer 10K Ohm Diode: IN4001, 2x Zener IN752 Transistor: 2N2219, 2N2222
Here is a simple and easy to build circuit diagram of a 12V car battery charger: Components List: R1 = 1Kohms D1 = 1N4001 T1 = 220V/17V 4A Transformer R2 = 1.2Kohms D2 = 6.8V 0.5W zener LD1 = Green LED R3 = 470 ohms TR1 = 4.7Kohms trimmer LD2 = Red LED R4 =… Read More »
This battery charger circuit is used to recharge the rechargable lithium battery. The circuit comes from Molicel. Charging is accomplished with a constant current of 60 mA for AA cells to a cutoff of 2.4V per cell, at which point the charge must be terminated.
Here is the simple and low cost NiCd and NiMH battery charger circuit which can be used for various battery type and size. This battery charger use a regulator IC of LM317. Schematic diagram: The charge will start if a battery is connected between pins JP1-JP4 or JP2-JP4 or JP3-JP4. For example, if a battery… Read More »
This is LED emergency light that will turned on automatically when mains supply fails, and turned off when mains power resumes. This circuit produces highly bright because the use of ultra bright white LEDs. This circuit also has its own battery charger. When the battery is fully charged, the charging process will stop automatically.
Automatic Switching-on Emergency Light The schematic diagram shown right here is the automatic switching-on emergency light circuit which is controlled using IC. The most important capabilities of this circuit are: automatic switching-on of the light on main power failure and battery charger with overcharge protection. When mains electrical power is absent, relay RL2 is in… Read More »
This is low cost fully transistorised power inverter 60W circuit capable of driving medium loads of the order of 40 to 60 watts using battery of 12V, 15 Ah or higher capacity. Transistors T1 and T2 (BC548) form a 50Hz multivibrator. For obtaining correct frequency, the values of resistors R3 and R4 may have to… Read More »