Here is the circuit diagram of lantern dimmer / flasher designed by Tony Van Roon: There are two circuit modes: dimming and flashing. The flasher mode is useful for warning other drivers of your troubles and it may be adjusted to have a very short flash duration for long-term use as when the car must… Read More »
The following is LED Flasher circuit which use 2 transistors for LED switching. The circuit works similar to flip-flop operation. Components List: R1 = 10M ohm R2 = 1K – 100K ohm R3 = 470 ohm C1 = 0.47uF – 10uF/25V D1 = 1N914 Q1 = 2N3904 Q2 = 2N3906 Led = High Brightness Red… Read More »
Here the simple mic pre-amp circuit design based on single IC LM358. The circuit is very simple, inexpensive and easy to built. This mic pre-amplifier circuit operated with 9V DC voltage, you may use 9V battery for this circuit. Component Parts List: R1, R3, R4 = 10K R2 = 1K R5 = 100K-1M Potensiometer C1… Read More »
Here the circuit diagram of Maestro Boomerang pedal / Wah-Wah pedal for electric guitar effect. Note: Transistors Q1 and Q2 were designated P-2356. The Maestro Boomerang is not only a wide range wah wah pedal but also a volume pedal. It’s deemed as one of the best wah pedals ever built – and I totally… Read More »
Here the simple mixer circuit with 4 inputs and 2 operational amplifier (op-amp) modules: A basic mixer suitable for mixing microphones or even effects outputs. The overall gain from input to output is one if the pot related towards the input is full up. You can make this a net gain of ten (or any… Read More »
The following circuit is an distortion booster effect for your electric guitar. I don’t know whether this circuit is really works or not, you may try this circuit with your own risk. The circuit is very simple with required only ten electronic components : two transistors, two diodes, five resistors and two capacitors. Supply voltage… Read More »
The following scheme is the clock generator circuit diagram which build based on NAND Gate logic IC. You may use IC 7400 or 4011 for this circuit. The 7400 is a Transistor-Transistor Logic (TTL) type, while 4011 is Complementary metal–oxide–semiconductor (CMOS) type. IC 4011 is cheaper than 7400 but the 7400 is faster than 4011.… Read More »
The following diagram is a very easy and simple electronic combination lock based on IC LS7220. Component Part List: C1 = 1uF 25V C2 = 220uF 25V R1 = 2.2K Ohm Q1 = 2N3904 / 2N2222 D1 = 1N4148 / 1N4001-1N4007 K1 = 12V SPDT Relay / Any appropriate relay with 12V coil U1 =… Read More »
Here is the circuit diagram of battery tester designed by Matthew B.. This circuit can be used to measure the 1.5V and 9V battery. The circuit is very-very simple and very easy to built since it uses five resistors and a panel meter only, and of course it is inexpensive too. Components List: R1 =… Read More »