Here the circuit diagram of 50W power amplifier. The amplifier uses a pair of power transistors that are MJ2955 and 2N3055 to amplify the input signal. You must use a heatsink on those transistors. The below design diagram uses for single input/output channel, just built two similar circuit to make it dual channel (stereo). Schematic… Read More »
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are very cheap and easy to find in the electronic market in your area. The circuit has been assembled and tested with very good performance.
This is an active stereo tone control circuit using very well known op-amp IC of TL072. The circuit include mic pre-amp and mixer control. In this design, we have two inputs: one for line (stereo), one for microphone and has control of the three audio frequency (high/treble, medium and low/bass). It also provide balance control… Read More »
This is a simple and low cost dew sensor circuit that can be used to switch off any gadget automatically in case of excessive humidity. Dew (condensed moisture) adversely affects the normal performance of sensitive electronic devices. The main part of this circuit is a low cost dew sensor element (resistor type). Although dew sensor… Read More »
This is a small 12W audio amplifier over a load of 8 Ω, that combining the NE5534 integrated with a pair of V-MOSFET transistor output stage technology as we get excellent sound performance. MOSFET 2SK135 / 2SJ50 from Hitachi is used in this circuit. Input sensitivity of the circuit is 3V RMS maximum, the distortion factor… Read More »
This is the circuit diagram of 18W audio amplifier. The circuit is quite simple and inexpensive to built. It uses a pair of power transistor TIP41A and TIP42A for single channel operation. The power supply used for this circuit is dual polarity (splitted) power supply, use center tap transformer to build this kind of power… Read More »
This is the diagram of 4W stereo power amplifier built based stereo power IC LM2877 with a few of external components. The circuit required single power supply with voltage range of 6VDC – 24VDC. Heatsink is a must to prevent over heating on the IC.
Build based operational amplifier NE5532 and a couple of power transistor TIP41A / TIP42A, this audio amplifier circuit has capability to deliver up to 10W audio power output into 8 ohm speaker.. Amplifier Parts list: P1 22K = Log.Potentiometer P2 = 100K Log.Potentiometer R1 = 820R R2, R4, R8 = 4K7 R3 = 500R Trimpot… Read More »
This is the design diagram of 5 band graphic equaliser circuit build using operational amplifier chips, the NE5532 or LM833. The op-amp ICs is a good choice because of inexpensive and comes with fairly good quality output. Each IC contains dual op-amps circuit, so you will need 4 ICs of NE5532 or LM833 to build… Read More »