This is 68W power audio amplifier circuit which built based on single IC LM3886 from National Semiconductor. A LM3886 used for single channel operation. Dual polarity / split / symmetrical power supply used to operate this amplifier circuit. The LM3886 is a high-performance audio power amplifier capable of delivering 68W of continuous average power to… Read More »
This is a dual regulated and stabilized power supply, usually used to supply amplifier circuit, it also known as split powersupply. There are 3 output that are (+) voltage, (0) Ground (normal), and (-) voltage. The current output max about 0.3-0.5 A. For higher current output, power transistor is needed. Please take a note that… Read More »
Here the circuit diagram of 50W power amplifier. The amplifier uses a pair of power transistors that are MJ2955 and 2N3055 to amplify the input signal. You must use a heatsink on those transistors. The below design diagram uses for single input/output channel, just built two similar circuit to make it dual channel (stereo). Schematic… Read More »
This is an active stereo tone control circuit using very well known op-amp IC of TL072. The circuit include mic pre-amp and mixer control. In this design, we have two inputs: one for line (stereo), one for microphone and has control of the three audio frequency (high/treble, medium and low/bass). It also provide balance control… Read More »
The following is an electronic circuit called galaxy audio booster which serves to improve the performance of your audio system. This circuit uses an IC RC4558 in which there are two op-amp modules that can be used for stereo audio applications. The circuit is similar to stereo tone booster that uses the principle of High… Read More »
This is the circuit diagram of 18W audio amplifier. The circuit is quite simple and inexpensive to built. It uses a pair of power transistor TIP41A and TIP42A for single channel operation. The power supply used for this circuit is dual polarity (splitted) power supply, use center tap transformer to build this kind of power… Read More »
This is the speaker protection circuit, provides stereo speaker protection and prevents switch-on clicks and DC components on the output of the amplifier connected.
This is the light fence schematic diagram uses LDR as the light sensing. The fundamental issue with the greater part of standard light sensors is that they require exact arrangement of light bar to quiet the circuit throughout standby mode. The circuit portrayed here is sensitive to the point that it will catch a moving… Read More »
Build based operational amplifier NE5532 and a couple of power transistor TIP41A / TIP42A, this audio amplifier circuit has capability to deliver up to 10W audio power output into 8 ohm speaker.. Amplifier Parts list: P1 22K = Log.Potentiometer P2 = 100K Log.Potentiometer R1 = 820R R2, R4, R8 = 4K7 R3 = 500R Trimpot… Read More »