This is a 15W FM RF amplifier circuit which build based on RF Power Transistor 2SC2539. 2SC2539 is a silicon NPN epitaxial planar type transistor designed for RF power amplifiers in VHF band mobile radio applications. FM RF Amplifier Circuit Diagram: Coil Specifications: L1: 2T Coil diameter:4mm L2: in series 6pcs Toroidal ring L3: 4T… Read More »
Below is the circuit diagram and PCB layout of FM wireless microphone: The range of frequencies for the FM broadcast band is 90MHz (MHz = Megahertz or 90 million cycles per second). Because the FM microphone has a variable tuned circuit, it can be tuned to a quiet spot on your local FM broadcast band… Read More »
This is an active FM/AM/SW radio receiver antenna, can be used for FM radio receiver, AM radio receiver and SW (shortwave) radio receiver. This circuit use active component JFET VHF Amplifier MPF102 to boost the radio signal. It use 9VDC supply to work. On the shortwave band this active antenna is comparable to a 20… Read More »
This is long range FM transmitter with transmision power output is up to 15W. This 15W FM transmitter use power transistor BLY88C as the main transmitter amplifier. Building a good FM transmitter(88-110Mhz) begins with getting a good schematic. You don’t have to understand the precise working of the transmitter to build it. But some basic… Read More »
This is a mini fm transmitter circuit. I think this is the simplest one. Simple, easy and of course… inexpensive… The supply voltage is between 1.1 – 3 Volts with power consumption is 1.8 mA at 1.5 Volts. This circuit should be able to cover 30 – 50 meters of range max. at 1.5 Volts.… Read More »
Here the simple and low cost FM transmitter which powered using two transistors. This circuit may be tuned to operate over the range 87-108MHz with a range of 20 or 30 metres. The circuit works with 9V power supply, use regulated power supply for better quality. The coil L1 was consist of 7 turns on… Read More »
This is a simple, well designed 1.5 Watt FM Transmitter circuit using power transistor 2N2219A. This circuit should be able to cover 1-2 KM range. It use +5-30V power supply to work. Refer to the above diagram, the input source is an electret condenser microphone (you may try to use other input sources) and signal… Read More »
This is the diagram of 4W stereo power amplifier built based stereo power IC LM2877 with a few of external components. The circuit required single power supply with voltage range of 6VDC – 24VDC. Heatsink is a must to prevent over heating on the IC.
This circuit is a wireless car alarm system that is built using two circuit modules, namely modules of transmitter and receiver modules. This circuit works on FM radio waves. Car alarms can be used on vehicles that have a 6-12VDC power supply. You can use the voltage stabilizer if your car power supply is too… Read More »