Here the simple, low cost and easy audio booster circuit. It uses a transistor of 2N3392 ad the main amplifier. Component List: R1 = 47K R2 = 470K R3 = 10K R4 = 560R R5 = 270R C1 = 0.1uF/25v C2 = 3.3uF/25v C3 = 470uF/25V P1 = 100K Q1 = 2N3392 D1 = 5mm.… Read More »
This document contains schematic diagram of Orange 125MK3 including the guitar preamp section, feedback and power amplifier section. Preview:
The following diagram is an inverter circuit which will give you 220V AC 50Hz with maximum power output of 100W. This inverter built using transistors for both the square wave generator module and the amplifier module. Inverter Diagram: The Q1 and Q2 used generate square wave. Q5-Q8 amplify the signal and the transformer to increase… Read More »
Designed by Don Tillman, this guitar pre-amp circuit design is dedicated for people who don”t like op-amps module. This circuit is a discrete JFET pre-amplifier design, use 2N5457 as the main component. It has low noise, low distortion, low feedback, overloads gracefully, is small, etc.
Here the simple mixer circuit with 4 inputs and 2 operational amplifier (op-amp) modules: A basic mixer suitable for mixing microphones or even effects outputs. The overall gain from input to output is one if the pot related towards the input is full up. You can make this a net gain of ten (or any… Read More »
The following schematic diagram is a small surround sound decoder circuit. You may use this decoder surround sound systems for your home audio system to make the audio system sound more “alive”. Parts List: R1-2-7-8-12-13-18-19-20=47Kohm R3-4-5-6-21-22-34-35=10Kohm R9-10-11-14-15-16-17=15Kohm R=23-24-25-33-36=100ohm R26-27-28-31-32=100Kohm R29-30=5.6Kohm C1-8=47uF 25V C2-7-9-14-23=47nF 100V C3-6=1uF 100V C4-5-10=33pF 100V C11-12-15=10uF 25V C13=82nF C16=18pF 100V C17=100pF mini… Read More »
Below circuit is the tone booster circuit. According to the name of circuit, the purpose is to amplify the sound signal to become more powerful in both low and high frequencies. There is no potensiometer used for bass/treble adjustment. Transistor type: Q1 – ztx384 ; Q2 – BC415p The circuit’s peaks frequencies is at 5000… Read More »
The following diagram is the circuit diagram of low cost 12V stereo tone control which also available in kit, you may find the kit at electronic part store around your place. The circuit build based on ordinary tone control circuit, using two low cost transistors FCS9014 in each channel, so there are will be four… Read More »
This is the scheme diagram of passive surround circuit. Passive surround doesn’t need any active components and power supply to make the circuit works. The circuit just need the combination of resistors and electrolytic capacitors. Circuit Notes: This passive surround circuit MUST be connected after power amplifier module. Use full range type of loudspeaker. Do… Read More »