This is the circuit diagram of dancing LEDs which consists of 10 units LEDs. The 10 dancing LEDs circuit works like a audio level meter. The LEDs will be dance sequence with the sound level that entering the microphone. Components list: R1_____________10K 1/4W Resistor R2,R3__________47K 1/4W Resistors R4______________1K 1/4W Resistor R5,R6,R7______100K 1/4W Resistors R8____________820R 1/4W… Read More »
This is the LED flashing circuit, since the shape used in this circuit was hearth shape, then we call it LED flashing heart circuit. The circuit is quite simple, low cost, easy to built. Alternatively, you could be create another shape, not just heart shape. Schematic diagram: Component list: Resistors R1, R2 – 470 ohm,… Read More »
The above diagram is a basic Uninterupted Power Supply (UPS) circuit. This basic UPS circuit is a very simple and inexpensive. This circuit can be adapted/modified for other regulated and unregulated voltages by using different regulators and batteries. For a 15 Volt regulated supply, you may apply two 12V batteries connected in series (it will… Read More »
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are very cheap and easy to find in the electronic market in your area. The circuit has been assembled and tested with very good performance.
This is a very interesting circuit design to assemble. There are 4in1 amplifier module in a circuit board. 100W power amplifier using the TDA7294, for the VU meter uses IC LM3914. The tone control preamp uses the well-known IC 4558. The symmetrical power supply module also included in the PCB.
This is 120W power amplifier schematic using TO-3 package complementary transistors, NPN and PNP polarity. The well-known power transistor pair of 2N3055 and MJ2955 used in this circuit. +/- 50V symmetrical (split/dual polarity) power supply with minimum 3A electric current should be used for maximum performance.
Here is the circuit diagram and PCB design for relatively low cost DIY bass guitar preamp pedal uses FET K117 or equivalent. There is a bit difficult to build this kind circuit project, it’s require a good knowledge in electronics. This preamp has several features for the bass guitar instrument such as attenuator, low cut, mid… Read More »
This is the simple project of small sound amplifier for ears or often called hearing aid device or hearing loss amplifier. This circuit was already tested on some patients and give significant improvement in the hearing ability to the patients. It consumes a very small amount of power within the range of 10 milliwatts. Furthermore,… Read More »
This is the circuit diagram of TRIAC, SCR and Transistor tester. This is a very simple circuit which can be used for testing of SCRs as well as triacs. The circuit could even be used for checking of PNP and NPN transistors. The circuit works on 3V DC, derived using a zener diode in conjunction… Read More »