This is a mini FM transmitter built and powered using 2 transistors, designed by Tony van Roon. This small transmitter is simple to build and its transmissions could be picked up on any common FM radio. It possesses a range of approximately 1/4-mile (400 meters) or even more, depending on the line-of-sight, obstructions by big… Read More »
This is the circuit diagram of low forward-drop rectifier. A TMOS power FET (Q1) and a LM393 comparator provide a high-efficiency rectifter circuit. When VA exceeds VB, U1’s output becomes high and Q1 conducts. Conversely, when VB exceeds VA, the comparator output becomes low and Q1 doesn’t conduct.
This is an easy FM tracking transmitter circuit project :). The scheme designed by Tony van Roon, and here the FM transmitter tracker diagram: Components List: R1 = 10K C1 = 100uF/10V C2 = 10nF C3 = 4-40pF trimmer capacitor C4 = 4.7pF IC1 = LM3909 Q1 = 2N3904 NPN transistor LED1 = Red LED/or… Read More »
Touch alarm circuit is widely used for security, which is installed on the door. The advantages of this alarm is because the cost is cheap and difficult to detect by burglars / intruders. The following is an example of a touch of alarm circuit which is designed by Tony Van Roon. Components List: R1 =… Read More »
This is the scheme diagram of automatic 9V battery charger circuit, the parts list provided below the schematic image. The circuit was designed by Jan Hamer, translated by Tony Van Roon dan republished in this circuit diagram site. The circuit details are based on european standards: 120E, 150E, etc. The ‘E’ just stands for Ohms… Read More »
Simple and easy build of sensitive FM transmitter circuit. The circuit only requires 2 transistors to work. *L1 = 0.1 Uh, 6 to 8 turns of 22 ga. hookup wire close wound around a 1/4 inch diameter non-conductive core such as a pencil Circuit Notes: Typically the default for the capacitors model is ceramic, preferably… Read More »
Here is the circuit diagram of lantern dimmer / flasher designed by Tony Van Roon: There are two circuit modes: dimming and flashing. The flasher mode is useful for warning other drivers of your troubles and it may be adjusted to have a very short flash duration for long-term use as when the car must… Read More »
The following scheme diagram is the battery charger circuit for 6V Gel Cell battery type only. Components List: R1 = 22 ohm, 1W R2 = 270 ohm R3 = 220 ohm *R4 = 715 ohm, 1% *R5 = 3.57K, 1% *R6 = 1.40K, 1% *R7 = 1.47K, 1% C1 = 0.1uF, ceramic C2 = 0.1uF,… Read More »
The following diagram is the schematic diagram of Ni-CAD battery charger circuit which featured with current and voltage limiting to keep the battery lifetime. The lamp L1 will be light brightly and the LED will be out when the battery is low and battery charging in progress, but the LED is very bright and the… Read More »