This 400W power amplifier circuit often called as “safari” amplifier. The below circuit design is for single channel only, build two identical circuit for dual/stereo channels. The 400W power amplifier designed using two couples of power transistors that are TIP31 with TIP32 and 2N3055 with MJ2955. These types transistor are well known and widely used… Read More »
The following is a circuit of a simple AM transmitter. This circuit is available in kit form and can work well since the kit available on market. This circuit uses a combination of transistors SA101 and SA103, as the modulation signal amplifier.
The following circuit is a 5W stereo audio amplifier, built based on single amplifier IC TA7227. The TA7227 can be used for dual mode (stereo amp) and single mode (bridge connection/mono amp). This IC type featured some circuit protection: thermal protection, over voltage protection, current limitter and BTL DC short connection. The tone control circuit… Read More »
This 300W OCL power amplifier -i’m sorry for the blur diagram, but it should be readable- use 4 pairs of 2N3055 dan MJ3055 transistor as the main power components. This is good circuit, i’ve built this OCL (ouput capacitor-less) power amplifier circuit for my school project, and of course i use it for my home… Read More »
Here’s a circuit of 7W audio amplifier that is very simple and very easy to build. This amplifier is built using TBA810 as the main component with the support of a few passive components. This circuit can work well, kits and components of this circuit can be found easily at an electronics store in your… Read More »
Below is a 80W audio amplifier circuit is constructed by using a power IC TDA7295. With a very simple design, makes this circuit very easy to build. TDA7295 has many features to support your audio system, the most important is that the IC has very low distortion and very low noise feature. Schematic diagram: PCB… Read More »
Here the stereo power amplifier based on single IC STK4141II. This stereo amplifier circuit will deliver 25W audio power on each output channel. Recommended voltage is 27.5V for 8 ohms speaker and 24.5V for 4 ohms speaker while the maximum voltage to supply this circuit should be about 41 VDC. This circuit operated with dual… Read More »
This is the circuit diagram of 50W power amplifier based on audio power amplifier IC STK-1050. Symmetrical power supply used to operate this circuit with maximum voltage rated at 53V and recommended supply is 36V. This is a single channel (mono) amplifier circuit, for stereo audio system, you should build two similar circuit. Power supply with… Read More »
Here the great 35W power amplifier with single IC STK-082 from Sanyo Semiconductor. Simple circuit with high power output.. 🙂 This circuit uses symmetrical (dual polarity) power supply with maximum power voltage is 43V based on the datasheet document. The recommended voltage operation is +/- 30V. For stereo application, you just need to build two… Read More »