This is the schematic diagram of solar powered mobile phone battery charger. The circuit is designed to charge the battery from a source with a lower voltage. Do not use it to charge the battery with the same or lower voltage than the voltage which is generated by the solar panel. For proper operation of… Read More »
Powered with solar panel, the circuit will give you 5V pure regulated DC voltage. This solar cell power supply circuit is made up of an oscillator transistor as well as a regulator transistor. The solar panel charges the battery when sunlight is bright enough to generate a voltage above 1.9v. A diode is necessary between… Read More »
The following diagram is the circuit diagram of Class-D audio power amplifier which built based on power chip TDA8929T. About TDA8929T: The power IC TDA8929T is the controller of a two-chip set for a high efficiency class-D audio power amplifier system. The system is divided into two chips: TDA8929T; the analog controller chip inside a… Read More »
This is the scheme diagram of automatic 9V battery charger circuit, the parts list provided below the schematic image. The circuit was designed by Jan Hamer, translated by Tony Van Roon dan republished in this circuit diagram site. The circuit details are based on european standards: 120E, 150E, etc. The ‘E’ just stands for Ohms… Read More »
The following scheme diagram is the battery charger circuit for 6V Gel Cell battery type only. Components List: R1 = 22 ohm, 1W R2 = 270 ohm R3 = 220 ohm *R4 = 715 ohm, 1% *R5 = 3.57K, 1% *R6 = 1.40K, 1% *R7 = 1.47K, 1% C1 = 0.1uF, ceramic C2 = 0.1uF,… Read More »
The following diagram is the schematic diagram of Ni-CAD battery charger circuit which featured with current and voltage limiting to keep the battery lifetime. The lamp L1 will be light brightly and the LED will be out when the battery is low and battery charging in progress, but the LED is very bright and the… Read More »
The following diagram is the schematic diagram of 12V NiCAD battery charger with charging rate of 200mA/Hour. Components List: Resistor: 1 K Ohm, 68 Ohm, 2 K Ohm, Potensiometer 10K Ohm Diode: IN4001, 2x Zener IN752 Transistor: 2N2219, 2N2222
This is the circuit diagram of 50W power amplifier based on audio power amplifier IC STK-1050. Symmetrical power supply used to operate this circuit with maximum voltage rated at 53V and recommended supply is 36V. This is a single channel (mono) amplifier circuit, for stereo audio system, you should build two similar circuit. Power supply with… Read More »
The above diagram is a basic Uninterupted Power Supply (UPS) circuit. This basic UPS circuit is a very simple and inexpensive. This circuit can be adapted/modified for other regulated and unregulated voltages by using different regulators and batteries. For a 15 Volt regulated supply, you may apply two 12V batteries connected in series (it will… Read More »