The following scheme is the clock generator circuit diagram which build based on NAND Gate logic IC. You may use IC 7400 or 4011 for this circuit. The 7400 is a Transistor-Transistor Logic (TTL) type, while 4011 is Complementary metal–oxide–semiconductor (CMOS) type. IC 4011 is cheaper than 7400 but the 7400 is faster than 4011.… Read More »
This is an audio mixer circuit which designed along with VU meter circuit. The circuit is for one channel input, if you need, for example 5 channel mixer, then you need to build 5 similar circuits. The this audio mixer uses three potensiometers to adjust volume level, low frequency (bass) level and high frequency (treble)… Read More »
This is the circuit diagram of UHF band TV antenna booster with 15dB gain power. This low cost antenna booster is simple and easy to build.It use single transistor BF180 to boost te UHF signal. Since this is an active circuit of UHF TV antenna booster, it will require a 12v power supply to operate.… Read More »
Here the simple and low cost FM transmitter which powered using two transistors. This circuit may be tuned to operate over the range 87-108MHz with a range of 20 or 30 metres. The circuit works with 9V power supply, use regulated power supply for better quality. The coil L1 was consist of 7 turns on… Read More »
Here is the 100W RMS audio amplifier schematic diagram: This circuit is quite simple but will give you high quality audio output. Take a note that above diagram designed for single input and single output (mono system). For stereo system, you need to build two similar circuits.
The above diagram is a basic Uninterupted Power Supply (UPS) circuit. This basic UPS circuit is a very simple and inexpensive. This circuit can be adapted/modified for other regulated and unregulated voltages by using different regulators and batteries. For a 15 Volt regulated supply, you may apply two 12V batteries connected in series (it will… Read More »