This is the scheme diagram of passive surround circuit. Passive surround doesn’t need any active components and power supply to make the circuit works. The circuit just need the combination of resistors and electrolytic capacitors. Circuit Notes: This passive surround circuit MUST be connected after power amplifier module. Use full range type of loudspeaker. Do… Read More »
The following image is the scheme diagram of six LED stereo VU display circuit which build using Dot/Bar Display Driver IC LM3915. This VU display should be connected before amplifier module circuit. You may connect this circuit at pre-amp output, tone control input/output or equaliser input/output. This circuit powered with 12V DC supply. About LM3915:… Read More »
The following diagram is the circuit diagram of 20 band stereo graphic equaliser which will controlling the audio signal in specific frequency range. The power supply used for this circuit is symmetrical (dual polarity) type, 15V DC.
This is a very simple FM receiver which build based on one transistor only. No chip or another active component. The output is connected to earphones, you need an amplifier circuit if you want to listen the radio with a loudspeaker.
Here is the AM Radio receiver circuit diagram based on old single IC MK484. Components List: R9, R10_________ 6R8 R6_____________ 100R R3_____________ 1K R1_____________ 4K7 R7_____________ 5K6 R4_____________ 10K R2_____________ 100K R5_____________ 150K R8_____________ 820K Pot_____________ 10K log pot Coil & ferrite bar set C7______________ 470p ceramic C, C4, C5, C6_____ 470nF monoblock C2______________ 100nF… Read More »
This circuit is a powerful three stage, 9V FM transmitter (Tx) with a range of up to 1 kilometer in the open. It uses an RF transistor in its output stage and two BC547″s for the first two stages. Distance of trans-mission is critically dependent on the operating Conditions (in a building or out on… Read More »
This is the circuit diagram of UHF band TV antenna booster with 15dB gain power. This low cost antenna booster is simple and easy to build.It use single transistor BF180 to boost te UHF signal. Since this is an active circuit of UHF TV antenna booster, it will require a 12v power supply to operate.… Read More »
This is the circuit of LED color fade effect. Just like the name of the circuit, the light intensity of LEDs in this circuit will fade from high intensity to low intensity and then off. Here the final result preview:
This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram: