This is 68W power audio amplifier circuit which built based on single IC LM3886 from National Semiconductor. A LM3886 used for single channel operation. Dual polarity / split / symmetrical power supply used to operate this amplifier circuit. The LM3886 is a high-performance audio power amplifier capable of delivering 68W of continuous average power to… Read More »
Here the schematic diagram of 70W power amplifier with MOSFET for your audio system. There are possible alternative input stage transistors, the Toshiba 2SA970BL and 2SC2240BL, which appear to be good substitutes for the Hitachi 2SA1085E and 2SC2547E. The ‘BL’ suffix is the high gain group. Alternatives for the Sanyo 2SC2911 and 2SA1209 are the… Read More »
This is a 18 Watt audio amplifier circuit based on power IC HA13118. The supply voltage required for this circuit is 8 – 18V DC, at least 1 to 2 Amps. Maximum output power will only be obtained with a power supply of 18V at greater than 2 A, using a 4 ohm speaker. The… Read More »
This is an amplifier circuit with gain music output power up to 7W. It uses IC TDA2003 as main component. This 7 watt audio amplifier circuit is small but powerful multi purpose amplifier. IC TDA2003 provides a high output current capability (up to 3.5A) very low harmonic and cross-over distortion.
This is 2 x 3W stereo audio amplifier based on IC power BA5406. This circuit which will give you 3W power in each channel. This circuit will be great for indoor audio system. Components List: R1, R2 = 120 ohm R3, R4 = 2R2 ohm C1, C2, C11, C12 = 220nF nonpolar capacitor C3, C4,… Read More »
This 4W Audio Amplifier circuit is powered by 2 pieces of transistor TIP41. The circuit is very simple and incorporates darlington output transistors that will provide more than enough output current than is needed to drive a 3-ohm speaker. The 4W audio amplifier circuit is very simple and incorporates darlington output transistors that will provide… Read More »
This a simple stereo electret microphone pre amplifier circuit. The below design diagram is the design for single channel, but the design of PCB layout is for stereo design og electret mic pre amp. For maximum performance, better quality, use solid capacitors or film capacitors and metal film resistors (1% tolerance). schematic diagram:
This is high fidelity, high quality 25W HiFi audio amplifier circuit delivers great audio performance. You don’t need pre amplifier circuit for this design since it can be directly connected to the input devices such as computers, phones, radios, TVs, etc. Component list: R1,R4 = 47K 1/4W Resistors R2 = 4K7 1/4W Resistors R3 =… Read More »
This is 20 watt audio amplifier circuit design which use IC LM1875 as main component. This circuit is simple and very easy to built. For stereo channel, you need to build the two same circuits which will amplify the both of audio channels (right and left channel). Dual polarity / symmetrical power supply required for… Read More »