Here the simple schematic of multitone siren alarm circuit. This multitone siren is effective for reverse horns, burlgar alarms, and many others. It generates five various audio tones and is much more earcatching than a single-tone siren.
This is the FM transmitter circuit which apply 4 radio frequency stages, that are a VHF oscillator designed around transistor BF494 (T1), a preamplifier designed around transistor BF200 (T2), a driver designed around transistor 2N2219 (T3) and also a power amplifier designed around transistor 2N3866 (T4). A condenser microphone is wired at the input of… Read More »
1000W Power Inverter circuit diagram: This is the power inverter circuit based MOSFET RFP50N06. The inverter capable to handle loads up to 1000W, it’s depended on your power inverter transformer. The RFP50N06 Fets are rated at 50 Amps and 60 Volts. Heatsink is required for cooling the MOSFETs. You may add some MOSFETs with parallel… Read More »
This is the very simple way to play a song with single 1.5 battery. You can build this circuit for gift acceccories. When the gift opened, then a song will be played.. It’s easy and cheap right..? 😀 . It just use a single small chip which will generate a song which already planted inside… Read More »
The following diagram is the schematic diagram of 4 transistors FM transmitter circuit designed by Paul K. Sherby. Components List: R1,R2,R8 = 1K R3 = 100K R4 = 150K R5,R7 = 10K R6 = 220 ohm R9 = 10 ohm P1 = 5K trimpot D1 = 1N4002 Q1,Q2 = 2N3904 Q3,Q4 = 7001, NTE123AP C1… Read More »
This is Micro-Spy circuit which designed using FET components.. Circuit Notes:
This circuit is a powerful three stage, 9V FM transmitter (Tx) with a range of up to 1 kilometer in the open. It uses an RF transistor in its output stage and two BC547″s for the first two stages. Distance of trans-mission is critically dependent on the operating Conditions (in a building or out on… Read More »
This is a simple audio pre-amplifier circuit using single transistor 2N3904. This easy circuit provides good gain to weak audio signals such as electret microphone. Use it in front of an RF oscillator to make an RF transmitter that’s very sensitive to sound. Power supply used for this circuit is wide range from 3VDC to… Read More »
This is the circuit diagram of UHF band TV antenna booster with 15dB gain power. This low cost antenna booster is simple and easy to build.It use single transistor BF180 to boost te UHF signal. Since this is an active circuit of UHF TV antenna booster, it will require a 12v power supply to operate.… Read More »