Here the low resistance connection tester which can be used as cable or wire tester, soldered joints and other types of connection with resistance value between 0.25 and 4 ohm. Circuit Notes: This simple circuit uses a 741 op-amp in differential mode as a continuity tester.
This is the circuit diagram of 12 Volts, 4 Amperes Solar Photovoltaic (PV) battery charger which will be suit to charge a 12V battery or accumulator. The circuit handles up to 4 amps of current from a solar panel, which equates to about 75 watts of power. A charging algorithm called “pulse time modulation” is… Read More »
Here the simple schematic of multitone siren alarm circuit. This multitone siren is effective for reverse horns, burlgar alarms, and many others. It generates five various audio tones and is much more earcatching than a single-tone siren.
Here the simple, low cost and easy audio booster circuit. It uses a transistor of 2N3392 ad the main amplifier. Component List: R1 = 47K R2 = 470K R3 = 10K R4 = 560R R5 = 270R C1 = 0.1uF/25v C2 = 3.3uF/25v C3 = 470uF/25V P1 = 100K Q1 = 2N3392 D1 = 5mm.… Read More »
This is the scheme diagram of automatic 9V battery charger circuit, the parts list provided below the schematic image. The circuit was designed by Jan Hamer, translated by Tony Van Roon dan republished in this circuit diagram site. The circuit details are based on european standards: 120E, 150E, etc. The ‘E’ just stands for Ohms… Read More »
This is the circuit diagram of Fuzz Face mods, guitar effect pedal. This is a modified diagram and simpler than the original Fuzz Face diagram. You will find apparently two identical designs of the fuzz face. In one Q1 and Q2 had been PNP germanium AC128 or NKT275 types, in the other they had been… Read More »
Here the schematic diagram of Axe Grinder Electric Guitar Effect pedal. You may download the PDF version at the end of the post. The Axe Grinder is designed with a few key fetures in mind, it not only serves a wide range of distortion sounds clipping part of the effect, it also gives the user… Read More »
The following is a circuit of a simple AM transmitter. This circuit is available in kit form and can work well since the kit available on market. This circuit uses a combination of transistors SA101 and SA103, as the modulation signal amplifier.
This is a stereo VU booster circuit diagram based on transistor FCS9014 which usually used for pre-amp and regulator circuit and switching. With simple circuit design, this device could be built easily. Scheme diagram, bottom PCB layout and component placement provided on the following image: This circuit should be connected to audio channel before amplifier… Read More »