Here is the 100W RMS audio amplifier schematic diagram: This circuit is quite simple but will give you high quality audio output. Take a note that above diagram designed for single input and single output (mono system). For stereo system, you need to build two similar circuits.
This is high fidelity, high quality 25W HiFi audio amplifier circuit delivers great audio performance. You don’t need pre amplifier circuit for this design since it can be directly connected to the input devices such as computers, phones, radios, TVs, etc. Component list: R1,R4 = 47K 1/4W Resistors R2 = 4K7 1/4W Resistors R3 =… Read More »
This is the scheme diagram of 20 Watt stereo audio amplifier which use dual IC TDA2005, one IC for left channel and the another one for right channel. Each IC will give you 20 watt output, so the output will be 2×20 Watt. The supply voltage for this circuit is 8VDC to 18VDC, use regulated… Read More »
This is 20 watt audio amplifier circuit design which use IC LM1875 as main component. This circuit is simple and very easy to built. For stereo channel, you need to build the two same circuits which will amplify the both of audio channels (right and left channel). Dual polarity / symmetrical power supply required for… Read More »
TA7227 Datasheet 5W stereo audio amplifier circuit
This the Good Quality FM transmitter for your stereo or any other amplifier gives you a pretty good signal strength up to a range of 500 metres having a power output of about 200 mW. This circuit can be operated with a 9V battery. The audio-frequency modulation stage is constructed close to transistor BF494 (T1),… Read More »
Here the simple mic pre-amp circuit design based on single IC LM358. The circuit is very simple, inexpensive and easy to built. This mic pre-amplifier circuit operated with 9V DC voltage, you may use 9V battery for this circuit. Component Parts List: R1, R3, R4 = 10K R2 = 1K R5 = 100K-1M Potensiometer C1… Read More »
The following schematic diagram is a small surround sound decoder circuit. You may use this decoder surround sound systems for your home audio system to make the audio system sound more “alive”. Parts List: R1-2-7-8-12-13-18-19-20=47Kohm R3-4-5-6-21-22-34-35=10Kohm R9-10-11-14-15-16-17=15Kohm R=23-24-25-33-36=100ohm R26-27-28-31-32=100Kohm R29-30=5.6Kohm C1-8=47uF 25V C2-7-9-14-23=47nF 100V C3-6=1uF 100V C4-5-10=33pF 100V C11-12-15=10uF 25V C13=82nF C16=18pF 100V C17=100pF mini… Read More »
This is a low noise and distortion pre-amplifier and tone control circuit in one module. Using a special IC TDA1524A, this simple circuit is easy to build and will drive most of power amplifier. Schematic diagram: