This is an easy, low cost and easy built circuit of an electronic horn which is designed close to quadruple op-amp IC LM3900 (IC1). IC LM3900 has four independent operational-amplifiers (A1 through A4) having a large output voltage swing. It is able to operate at up to 32V DC. The 1st op-amp (A1) is designed… Read More »
This diagram is the schematic diagram of telephone switcher using relays. This device connects to the telephone line and can be used to remotely control up to 4 relay outputs using a DTMF (tone dialing) telephone. A number of user settings are available to improve the useability and security of the device. The kit comes… Read More »
Here the circuit diagram of Maestro Boomerang pedal / Wah-Wah pedal for electric guitar effect. Note: Transistors Q1 and Q2 were designated P-2356. The Maestro Boomerang is not only a wide range wah wah pedal but also a volume pedal. It’s deemed as one of the best wah pedals ever built – and I totally… Read More »
Below diagram is the circuit diagram of Dan Amstrong Blue Clipper fuzz, effect for electric guitar: The Blue Clipper is a thick sounding fuzz with gargantuan sustain. The Blue Clipper delivers a nice, thick fuzz like the Muff, but this unit packs a little more bite. The big difference is that the gain level is… Read More »
Here the schematic diagram of Axe Grinder Electric Guitar Effect pedal. You may download the PDF version at the end of the post. The Axe Grinder is designed with a few key fetures in mind, it not only serves a wide range of distortion sounds clipping part of the effect, it also gives the user… Read More »
Below is a mic compressor circuit that uses transistors as active components. VR1 and VR 2 is used to control the tone from the microphone, while VR3 and VR4 strengthening works to control the audio signal in the compressor mic. C10 must be used in this circuit. The circuit I got from my local computer… Read More »
The following image is the scheme diagram of six LED stereo VU display circuit which build using Dot/Bar Display Driver IC LM3915. This VU display should be connected before amplifier module circuit. You may connect this circuit at pre-amp output, tone control input/output or equaliser input/output. This circuit powered with 12V DC supply. About LM3915:… Read More »
This is a stereo VU booster circuit diagram based on transistor FCS9014 which usually used for pre-amp and regulator circuit and switching. With simple circuit design, this device could be built easily. Scheme diagram, bottom PCB layout and component placement provided on the following image: This circuit should be connected to audio channel before amplifier… Read More »
Here the great 35W power amplifier with single IC STK-082 from Sanyo Semiconductor. Simple circuit with high power output.. 🙂 This circuit uses symmetrical (dual polarity) power supply with maximum power voltage is 43V based on the datasheet document. The recommended voltage operation is +/- 30V. For stereo application, you just need to build two… Read More »