The following circuit is a simple fire alarm circuit based NE555 timer and use thermistor as a temperature detector. This sensor will activate the transistor when the temperature is in high value.
The thermistor will have a low resistance at high temperature, while at low temperature, the transistor resistance is high. This characteristic of thermitor is used to build the fire alarm.
The difference value of thermistor will decide the transistor 1 and transistor 2 to switching on or off, while TI and T2 has function to drive the NE555 to generate audio frequency. We can say that the thermistor’s condition (its sensing) will determine the alarm to be on or off. The T3 transistor used to drive the speaker so the audio frequency from NE555 can be heard by our ears.
This circuit powered using 6V DC supply. You may use battery or power supply adapter to supply this simple fire alarm circuit.
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
what is the temperature range of the thermisitor?
Gdday,my is not comment but question.I need to wire about 5 fire alarm with smoke detector.I need wiring diagram
can we replace SL100B with CL100S
I tried it and it worked