Audio

Sine Wave to Square Wave Converter

This sine wave to square wave converter circuit is expected to provide good square waves changing a sine wave delivered from an existing generator. Its primary feature consists in the fact that no power-source is required: in this manner it can be simply connected between a sine wave generator and the device under test.

The input sine wave sustains a voltage doubler formed by C1, C2, D1 & D2 that powers the IC. IC1A amplifies the input sine wave, other inverters included in IC1 squaring the signal and delivering an output square wave of equal mark/space ratio and good rise and fall times through the entire 20Hz-20KHz range.

Sine Wave to Square Wave Converter Circuit Notes:

  • Minimum sine wave input amplitude needed for good performance: 750mV RMS.
  • Best performances are obtained with an input sine wave amplitude from 1V RMS onwards.
  • Output square wave amplitude is proportional to input amplitude.
  • Output square wave amplitude with 1V RMS input: 3V peak to peak, with R2 set at max.
  • Minimum output square wave amplitude: 2V peak to peak, with R2 set at max.
  • Substituting the two silicon diodes with germanium types (e.g. AA118, AA119), the minimum input threshold can be lowered.

This sine wave to square wave converter come from redcircuits.com

circuit diagram

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago