Categories: Linear Amplifier

TDA8929T Class-D Audio Power Amplifier

The following diagram is the circuit diagram of Class-D audio power amplifier which built based on power chip TDA8929T.

About TDA8929T:
The power IC TDA8929T is the controller of a two-chip set for a high efficiency class-D audio power amplifier system. The system is divided into two chips:

  • TDA8929T; the analog controller chip inside a SO24 package
  • TDA8926J/ST/TH or TDA8927J/ST/TH; a digital power stage inside a DBS17P, RDBS17P or HSOP24 power package.

With this chip set a compact 2 ´ 50 W or 2 ´ 100 W audio amplifier system might be constructed, operating with high efficiency and quite reduced dissipation. No heatsink is needed, or depending on source voltage and load, a really tiny one. The system operates above a wide supply voltage range from ±15 as much as ±30 V and consumes an extremely minimal quiescent current.

TDA8929T Features:

  • Low distortion
  • Fixed gain of 30 dB Single-Ended (SE) or 36 dB Bridge-Tied Load (BTL)
  • Operating voltage from ±15 to ±30 V
  • Very low quiescent current
  • Internal switching frequency can be overruled by an external clock
  • No switch-on or switch-off plop noise
  • Good ripple rejection
  • Diagnostic input for short-circuit and temperature protection
  • Usable as a stereo Single-Ended (SE) amplifier or as a mono amplifier in Bridge-Tied Load (BTL)
  • Start-up safety test, to protect for short-circuits at the output of the power stage to supply lines
  • Electrostatic discharge protection (pin to pin)

The schematic diagram, PCB layout design, characteristic information and the complete explanation about this TDA8929T Class-D Audio Power Amplifier already described in the datasheet document.

Download the TDA8929T datasheet

circuit diagram

Recent Posts

Power Amplifier 45W Using uPC 1230 + Pre Amp Head uPC 1032

This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…

55 years ago

Horn and Lamp Flasher Circuit for Car Reversing Gear Mode

The Horn Circuit This is a basic circuit of car horn and lamp flasher that…

55 years ago

Alarm Circuit for Drinking Water

This is the circuit diagram of drinking water alarm based a small water sensor by…

55 years ago

200W MOSFET Amplifier based IRFP250N

Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…

55 years ago

300W RMS Stereo Power Amplifier based IC TDA7294

This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…

55 years ago

Stereo Tone Control with Line In + Microphone Mixer

This is an active stereo tone control circuit using very well known op-amp IC of…

55 years ago