The following scheme diagram is the circuit diagram of VOX treble booster effect. A treble booster is an effects unit used by guitarists to boost volume and especially the high end of their tonal spectrum, and was popular mostly during the 1960s.
VOX made a variety of boosters that were meant to be plugged directly into amplifiers or guitars. Roger McGuinn installed one into his Rickenbacker guitar in the 1960s.
Original VOX Treble Booster diagram:
Modified VOX treble booster diagram:
The modified treble booster circuit diagram is purposed to be used as an overdrive/distortion unit.
The input capacitor is changed from 500pF to 0.01 uF (1000pF) or 0.022 uF (2200 pF) to allow more bass in. This usually overloads the booster and causes crunchy distortion.
Download VOX treble booster effect circuit in PDF format from the following link:
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…