This is the circuit diagram of white line follower toy. The actuator of the toy is the DC motor. This circuit can be used for a toy car to follow a white line, this circuit also known as very simple robot: “line follower without microcontroller”. The motor is either a 3v type with gearing to steer the car or a rotary actuator or a servo motor.
How the circuit work..?
When equal light is detected by the photo resistors the voltage on the base of the first transistor will be mid rail and the circuit is adjusted via the 2k2 potensiometer so the motor does not receive any voltage. When one of the LDR’s receives more (or less) light, the motor is turned on / activated. And the same thing will be happen when the other LDR receives less or more light.
You can see the below video as the result of this circuit project:
This is the circuit diagram of power amplifier 45W using power uPC 1230 as the…
The Horn Circuit This is a basic circuit of car horn and lamp flasher that…
This is the circuit diagram of drinking water alarm based a small water sensor by…
Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are…
This is the 300W RMS stereo power amplifier circuit project. This amplifier is based four…
This is an active stereo tone control circuit using very well known op-amp IC of…
View Comments
In my under standing servo motor here is only for turning the robot than how will robot run because there is no other motor?? and one other point is that in the video you use the robot with three tires so where you places servo motor? so basically i want to ask you is that how your robot is performing forward motion and how it turns?? I will wait for your answer...
thank you for circuit
yep, plz anyone tell me is it not quite similar to line follower robot?? whats the basic difference between them or what extra components use here to follow white line.
This circuit built without microcontroller. You are unable to control the motor speed and direction through the program.