This a simple stereo electret microphone pre amplifier circuit. The below design diagram is the design for single channel, but the design of PCB layout is for stereo design og electret mic pre amp. For maximum performance, better quality, use solid capacitors or film capacitors and metal film resistors (1% tolerance). schematic diagram:
Here is the circuit diagram of the classic 5W Tube Amplifier with EL84 as the final amplification component. This is a single channel amplifier (mono) of course with single input and single output. You should build the two similar circuit to make it stereo.
This is the circuit diagram of 35W Tube Power Amplifier with EL34. This tube amplifier designed in 1953 and worked from 1954 until 1989. If you’re interested with classic circuit and classic components, then you should try this circuit. The circuit is interesting but i think it is hard to find the tubes. Schematic Diagram:
This is the inverter circuit which capable to convert 12V DC to 220V AC dan handle about 50 Watts small electronic appliances. With this circuit, you can use a 12V accumulator / lead acid battery to operate some of your electronic appliances which not exceed 50W of total power consumption. Components List: R1=10Mohms R2=100ohms R3=1.2Kohms… Read More »
This is a simple, well designed 1.5 Watt FM Transmitter circuit using power transistor 2N2219A. This circuit should be able to cover 1-2 KM range. It use +5-30V power supply to work. Refer to the above diagram, the input source is an electret condenser microphone (you may try to use other input sources) and signal… Read More »
This is the circuit diagram of sound effects generator. All sounds in this circuit are generated by HT2884. The HT2884 is a CMOS LSI chip equipped with tone circuit, noise circuit, and other control logic to generate various sounds to be used in sound effects production. This IC features: single power supply (2.4V – 3.3V),… Read More »
This is electronic bird chirp sound generator circuit which used to produce a sound like bird’s chirp. The transformer is a small audio transformer, type LT700. The primary is center tapped with an impedance of 1Kohms at 1KHz . The secondary has an impedance of 8 ohms. The circuit works with 9V power supply.
This is Electronic Siren circuit diagram which use standard discrete components. The sound produced imitates the rise and fall of an American police siren. When first switched on the 10u capacitors is discharged and both transistors are off. When the push button switch is pressed to 10u capacitor will charge via the 22k resistor. This… Read More »