Here the circuit diagram of 50W power amplifier. The amplifier uses a pair of power transistors that are MJ2955 and 2N3055 to amplify the input signal. You must use a heatsink on those transistors. The below design diagram uses for single input/output channel, just built two similar circuit to make it dual channel (stereo). Schematic… Read More »
Here the analog flip-flop circuit which built based on 2 transistors work as switch. This is very easy made and very cheap circuit. You can use this circuit as “the first project” for your students… 🙂 and the result should be like this:
This is the simple and low cost AM transmitter schematic diagram built using transistor BC109C. The circuit is in two halfs, an audio amplifier and an RF oscillator. The oscillator is built around Q1 and associated components. The tank circuit L1 and VC1 is tunable from about 500kHz to 1600KHz. These components can be used… Read More »
Here the simple and low cost FM transmitter which powered using two transistors. This circuit may be tuned to operate over the range 87-108MHz with a range of 20 or 30 metres. The circuit works with 9V power supply, use regulated power supply for better quality. The coil L1 was consist of 7 turns on… Read More »