Category Archives: Power Electronics

DC to DC Converter +5V to +12V

This is the fixed 5V to 12V DC to DC converter. The circuit application converts input voltage of 5V (range 4.5V-5.5v) to 12V fixed regulated DC output. The circuit built based National regulator monolithic IC LM2586 which is specifically designed for flyback, step-up (boost), and forward converter circuit applications. The LM2586 will require a heat… Read More »

5V Regulated Solar Cell Power Supply

Powered with solar panel, the circuit will give you 5V pure regulated DC voltage. This solar cell power supply circuit is made up of an oscillator transistor as well as a regulator transistor. The solar panel charges the battery when sunlight is bright enough to generate a voltage above 1.9v. A diode is necessary between… Read More »

3-Rail (+12V) / (+5V) / (-5V) Regulated Power Supply

This circuit generates 3 source regulated voltages applying a minimum of electronic parts. The output DC voltage are +12V ; +5V and -5V. Diodes D2 and D3 conduct full-wave rectification, at the same time charging capacitor C2 on each halves of the alternating current cycle. At the same time, diode D1 with capacitor C1, and… Read More »

5VDC to 12VDC LT1070 Boost Converter

This is a 5VDC to 12VDC boost converter circuit built based LT1070. The LT1070/LT1071 are monolithic high power switching regulators. They can be operated in all standard switching configurations including buck, boost, flyback, forward,inverting and “Cuk”. A high current, high efficiency switch is included on the die along with all oscillator, control and protection circuitry.

3A Switching Power Supply Regulator

This is the circuit diagram of 3A switching power supply regulator: Simple and cheap, the circuit built based on well-known IC regulator LM317 with current booster of power transistor 2N3782. Don’t forget to add heatsink especially for power transistor 2N3782.

Current Output Multiplier for 78xx Regulator

This is the circuit diagram of current output multiplier designed for regulator IC LM78xx. By default, the regulator ID 78xx series will give maximum current output 1A – 1.5A. To increase the current output of this regulator, you may consider to build this circuit. The circuit is simple, easy built and inexpensive. Parts list: R1,… Read More »

Basic Dual Polarity Power Supply

This is a very basic dual polarity power supply circuit diagram, it also called symmetrical power supply or split power supply. Basically, it just need the following components: A Center Tapped Transformer Diode rectifier 4 units (or diode bridge 1 unit) Electrolityc capacitor 4 units

Page 5 of 11« First...34567...10...Last »