Touch Switch

Turn on and turn off your electrical devices using touch switch, so you can “play” your electronic devices more fun.. 🙂 . Touch switch don’t need mechanical part, so they will not worn out due to mechanical contact. Touch switches can be used in places where regular switches would not last, such as wet or… Read More »

7 Watt Audio Amplifier with IC TDA2003

This is an amplifier circuit with gain music output power up to 7W. It uses IC TDA2003 as main component. This 7 watt audio amplifier circuit is small but powerful multi purpose amplifier. IC TDA2003 provides a high output current capability (up to 3.5A) very low harmonic and cross-over distortion.

2 x 3W Stereo Audio Amplifier with IC BA5406

This is 2 x 3W stereo audio amplifier based on IC power BA5406. This circuit which will give you 3W power in each channel. This circuit will be great for indoor audio system. Components List: R1, R2 = 120 ohm R3, R4 = 2R2 ohm C1, C2, C11, C12 = 220nF nonpolar capacitor C3, C4,… Read More »

2x1W Stereo Amplifier with IC KA2209

This is 2x1W stereo amplifier circuit based on single IC KA2209. IC KA2209 is an equivalent IC to the TDA2822, you can use TDA2822 if you can’t find KA2209. It is ideal for battery powered operation since the supply required for this circuit is 2V to 9VDC. Power output depends critically on speaker resistance &… Read More »

1W Stereo Audio Amplifier using LM386N

This is 1W stereo audio amplifier with LM386N. The output power is 1 watt for each channel, so it should be use two ICs of LM386N National Semiconductor for stereo channel. This circuit belongs to kitsrus.com and the kit is available there or at electronickits.com. This circuit only need 10mA current with best voltage supply… Read More »

1W Audio Amplifier with TDA7052

This is the circuit diagram of 1W audio amplifier which use TDA7052 as the main component and other 5 pieces of components to support the main component. The ideal supply voltage of this circuit is about 6-12V and no heatsink required. The schematic is for mono audio channel, just build two similar circuit for stereo… Read More »

Flame, gas and smoke detector

Flame, gas and smoke detector for fire alarm. You can combine this circuit with alarm circuit. The output will be the relay which switch on and switch off the alarm. Schematic diagram:

Simple Fire Alarm with Thermistor and NE555

The following circuit is a simple fire alarm circuit based NE555 timer and use thermistor as a temperature detector. This sensor will activate the transistor when the temperature is in high value. The thermistor will have a low resistance at high temperature, while at low temperature, the transistor resistance is high. This characteristic of thermitor… Read More »



Page 50 of 57« First...102030...4849505152...Last »