This is linear power amplifier 2000 Watt which need advance knowledge in electronics since the schematic diagram is very complex for hand made circuit. I think you have to re-design the schematic diagram using circuit diagram software designer such as diptrace, eagle, expresspcb ect. Or just order the PCB online, they will be glad to… Read More »
This is an amplifier circuit with gain music output power up to 7W. It uses IC TDA2003 as main component. This 7 watt audio amplifier circuit is small but powerful multi purpose amplifier. IC TDA2003 provides a high output current capability (up to 3.5A) very low harmonic and cross-over distortion.
This 200 Watt high quality power audio amplifier will give you top class quality for loudspeaker 4 – 8 ohm. Frequency range 20-20000Hz, Voltage 24-36V with current max 5A. You need heatsink to keep the transistor from overheating. Itu use dual polarity power supply to work, then you may use this power supply to supply… Read More »
This is the scheme diagram of 20 Watt stereo audio amplifier which use dual IC TDA2005, one IC for left channel and the another one for right channel. Each IC will give you 20 watt output, so the output will be 2×20 Watt. The supply voltage for this circuit is 8VDC to 18VDC, use regulated… Read More »
This is a 200W power amplifier circuit project. The circuit features high power, good definition and very low noise. It delivers about 200 watts in 4 ohms loudspeaker: a 4 ohm speaker or two pieces of 8 ohm speakers in parallel. This 200W power amplifier using the complementary transistors of 2SC5200 and 2SA1943 as the… Read More »
This is the circuit diagram of 2000W class AB power amplifier uses 7 pairs MJ15003 and MJ15004 transistors for the final amplification block. The circuit operated with 90V DC symmetrical (dual polarity) power supply circuit. The transistors must be mounted on heatsink to prevent the overheating, maintain the transistors work in maximum performance.
This is a 2W RF amplifier circuit build with single power MOSFET LF2810A. Figure A Figure A is the schematic of the microstrip single stage RF amplifier. The amplifier is based on the M/A-Com LF2810A MOSFET. The transistor is actually a 10 watt, 28 volt part, but provides adequate gain for this application at 12… Read More »
This is the circuit diagram of mic condenser amplifier. The low-cost and compact mic condenser audio amplifier described right here is deliver good-quality audio of 0.5 watts at 4.5 volts. It could possibly be applied as a part of low-power transmitters, packet radio receivers, intercoms and walkie-talkies.
This is the circuit diagram of stereo tube amplifier using 6SQ7-GT and 6V6-GT. The tube amplifier circuit is uses the total of 5 power vacuum tube. The diagram is based on the output section design of typical late 1940’s old AM Trutone radio with 6 tubes. The output will be 4 Watts per channel (2x4W… Read More »