200 Watt High Quality Audio Amplifier

This 200 Watt high quality power audio amplifier will give you top class quality for loudspeaker 4 – 8 ohm. Frequency range 20-20000Hz, Voltage 24-36V with current max 5A. You need heatsink to keep the transistor from overheating.

Itu use dual polarity power supply to work, then you may use this power supply to supply the circuit. Use 5A transformer with center tap output, change the diode with bridge diode 5A, use capacitor minimum of 6800uF/63V for better output supply.

200 Watt High Quality Audio Amplifier Schematic and PCB Layout

Schematic diagram:

200 Watt High Quality Audio Amplifier circuit diagram

Component part list:

200 Watt High Quality Audio Amplifier circuit diagram

Description:

200 Watt High Quality Audio Amplifier circuit diagram

Top PCB Layout:

200 Watt High Quality Audio Amplifier circuit diagram

200 Watt High Quality Audio Amplifier circuit diagram

Bottom PCB Layout:

200 Watt High Quality Audio Amplifier circuit diagram

Good luck in bultd 200W high quality audio amplifier project 🙂


17 thoughts on “200 Watt High Quality Audio Amplifier

  1. Dinesh khasare

    Please tell me all capacitor voltage & value I will make this ckt today….

  2. circuit diagram

    It should be work. Yes, the speaker connected to the output of 2 TDAs because of it is an bridge amplifier.
    The circuit requires split / dual polarity power supply. It should be +36, GND and -36. The SUPPLY GND connected to the INPUT GND

  3. chickies

    I tried this circuit and it did not work. is the speaker connected to the outputs of the 2 tdas then how can it work? where is the speaker earth connected?

  4. s-vic

    this 200w amplifier, can i use my 4ohms 500w speaker?

  5. kumar

    please given clear circuit diagram and how many loudspeaker connected this circuit and bass, treble point please mention

  6. philippe

    what is possible output voltage of this cicuit?

  7. Kwabla Daniel Teye

    please help me build the transformer myself.

  8. Kwabla Daniel Teye

    Please help me build an equalizer circuit(from 5-20 bands) of high quality but low cost for the 200w amp.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.