This is a 200W power amplifier circuit project. The circuit features high power, good definition and very low noise. It delivers about 200 watts in 4 ohms loudspeaker: a 4 ohm speaker or two pieces of 8 ohm speakers in parallel. This 200W power amplifier using the complementary transistors of 2SC5200 and 2SA1943 as the… Read More »
This is the circuit diagram of stereo tube amplifier using 6SQ7-GT and 6V6-GT. The tube amplifier circuit is uses the total of 5 power vacuum tube. The diagram is based on the output section design of typical late 1940’s old AM Trutone radio with 6 tubes. The output will be 4 Watts per channel (2x4W… Read More »
This is a stereo audio amplifier circuit which will deliver 12W audio power output on each channel. This circuit built based on single IC TDA1521 or TDA1521Q, supported with a few external components. General purpose power supply can be used to operate this amplifier circuit, recommended voltage: 24VDC (asymmetrical). The TDA1521/TDA1521Q is a dual hi-fi… Read More »
This is a class AB 6-10W audio power amplifier circuit which built using a TDA2002 or TDA2003 power amplifier IC module. These are replacements for the original LM383 which is no longer available. It is easy to build and has a minimum of external components. The module has both short circuit protection and thermal protection.… Read More »
This 4W Audio Amplifier circuit is powered by 2 pieces of transistor TIP41. The circuit is very simple and incorporates darlington output transistors that will provide more than enough output current than is needed to drive a 3-ohm speaker. The 4W audio amplifier circuit is very simple and incorporates darlington output transistors that will provide… Read More »
This is the scheme diagram of 20 Watt stereo audio amplifier which use dual IC TDA2005, one IC for left channel and the another one for right channel. Each IC will give you 20 watt output, so the output will be 2×20 Watt. The supply voltage for this circuit is 8VDC to 18VDC, use regulated… Read More »
This long-range FM radio transmitter has an additional RF power amplifier stage, after the oscillator stage. The extra RF power amplifier used to strenght up the power output to become 200-250 milliwatts. With a great matching multi-element Yagi antenna or 50-ohm ground—plane antenna, this transmitter can give great good signal strength up to a distance… Read More »
Here the SW transmitter circuit based on IC BEL1895. This particular transmitter circuit works in shortwave HF band (6 MHz to 15 MHz), and can be applied for shortrange communication and for educational purposes. The circuit is composed of a mic amplifier circuit, a variable frequency oscillator, and modulation amplifier stages. Transistor T1 (BF195) is… Read More »