This is a simple and low cost Tube Head Vacuum Tube pre-amp circuit designed bu PAiA electronics: Vcc – Pin 1 IC1 +12v – Pin 8 IC2, IC3, IC4 -12v – Pin 4 IC2, IC3, IC4 Ground – Pin 8 IC1 IC1 – 4049 CMOS Hex Inverting Buffer IC2, 3, 4 – 5532 Dual Low-Noise… Read More »
The following scheme diagram is the battery charger circuit for 6V Gel Cell battery type only. Components List: R1 = 22 ohm, 1W R2 = 270 ohm R3 = 220 ohm *R4 = 715 ohm, 1% *R5 = 3.57K, 1% *R6 = 1.40K, 1% *R7 = 1.47K, 1% C1 = 0.1uF, ceramic C2 = 0.1uF,… Read More »
The following diagram is the circuit diagram of low cost 12V stereo tone control which also available in kit, you may find the kit at electronic part store around your place. The circuit build based on ordinary tone control circuit, using two low cost transistors FCS9014 in each channel, so there are will be four… Read More »
Here’s a circuit of 7W audio amplifier that is very simple and very easy to build. This amplifier is built using TBA810 as the main component with the support of a few passive components. This circuit can work well, kits and components of this circuit can be found easily at an electronics store in your… Read More »
This is a circuit of a touch switch used to turn on and turn off the electronic device that is connected to the 220V home electrical installations. This is a very simple circuit which use SCR T103 as the switching part. Components List: R1 : 2M2 R2 : 10K R3 : 1K R4 : 2K2… Read More »
Above scheme diagram is turbo bass circuit that can be used to multiply the low frequency sound signals (bass) on your audio system, it also called “bass booster” circuit. This circuit is an active circuit in which the incoming audio signal from the input will be strengthened in the first op-amp. The second op-amp that… Read More »
Here is the USB sound card circuit based on PCM2706 which dedicated for USB audio. With USB controller module inside PCM2706, there is no more additional programming to the IC. The computer system will automatically detect this circuit when connected to the USB port. You will get stereo audio channel output from this circuit. Schematic… Read More »
This is an audio mixer circuit which designed along with VU meter circuit. The circuit is for one channel input, if you need, for example 5 channel mixer, then you need to build 5 similar circuits. The this audio mixer uses three potensiometers to adjust volume level, low frequency (bass) level and high frequency (treble)… Read More »
Here is the circuit diagram of car headlight alarm. This device can be set for one or two functions: First, to indicate that the head lights (or the side lights) should be switched off after switching off the ignition contact. With this circuit, there should be no dead battery due to headlights that were left… Read More »