Here the analog flip-flop circuit which built based on 2 transistors work as switch. This is very easy made and very cheap circuit. You can use this circuit as “the first project” for your students… 🙂 and the result should be like this:
This is a ultrasonic motion detector (or movement detector) circuit. The circuit claimed has a high movement sensitivity. Even air moving (hot air rising, wind blowing) will trigger it when the trimpot is set near the most sensitive position. The transmitter sends out a steady ultrasonic tone at 40kHz. At this frequency the wavelength is… Read More »
This is the circuit design of unipolar stepper motor driver to control unipolar stepper motors with 5, 6 or 8 wires. It uses four MOSFET IRFZ44. This circuit can be operated in free-standing or PC-controlled mode.
Here is the circuit diagram of stereo digital volume control. This circuit could possibly be applied for upgrading your manual volume management within a stereo amplifier circuit. In this particular circuit, push-to-on switch S1 controls the forward (volume enhance) operation of the two channels while a identical switch S2 controls reverse (volume reduce) operation of… Read More »
This is the scheme diagram of automatic 9V battery charger circuit, the parts list provided below the schematic image. The circuit was designed by Jan Hamer, translated by Tony Van Roon dan republished in this circuit diagram site. The circuit details are based on european standards: 120E, 150E, etc. The ‘E’ just stands for Ohms… Read More »
The following is LED Flasher circuit which use 2 transistors for LED switching. The circuit works similar to flip-flop operation. Components List: R1 = 10M ohm R2 = 1K – 100K ohm R3 = 470 ohm C1 = 0.47uF – 10uF/25V D1 = 1N914 Q1 = 2N3904 Q2 = 2N3906 Led = High Brightness Red… Read More »
The following diagram is the circuit diagram of basic monostable multivibrator based IC timer 555. This circuit uses only 4 electronic components that are a timer IC, two capacitors and a resistor. Components List: A multivibrator is an electronic circuit used to implement a variety of simple two-state systems such as light emitting diodes, timers… Read More »
This is a sound generator based on general purpose timer IC 555. A flip-flop circuit is included, so this circuit will give sound output and blinking LED. There are 2 modules in this circuit that are flip-flop / LED flasher module and sound generator circuit modules which combined in one schematic diagram. This is a… Read More »
Here is the circuit diagram of ultrasonic sensor switch. There are many methods of wireless switching such as by using infrared, AM/FM signal, bluetooth, etc. This is an alternate wireless switching by using ultrasonic sensor. The distance of switching range should be more than 10 meters. This circuit produces and transmits ultrasonic sound of frequency… Read More »