This is a very easy and simple LED flasher with only three components: a flasher IC LM3909, a LED indicator and an electrolytic capacitor. The supply voltage is 1.5V, so it can be operated using a 1.5V battery which can be easily found on market. Component list: LED1 _________ Red LED C1 ___________ 100uf/16V IC1… Read More »
This is the glow plug control module unit to raise the air temperature inside the engine cylinder for quick and reliable starting, to extend the battery life and reduce the diesel consumption. In diesel engines, the air in the cylinders is not hot enough to ignite the fuel under cold conditions. Therefore every cylinder of… Read More »
There are many version of stepper motor type, also the many version of stepper motor controller design. This circuit is a general-purpose stepper motor controller that use IC TDA2030 as the driver. This circuit can be used with a wide range of operating voltages, from approximately 5 V to 18 V. It can drive the… Read More »
This is the schematic diagram of Infrared (IR) cordless headphone. Maybe it also can be called “wireless headphone”, but it use infrared as sound signal carrier. It use a pair of circuit diagrams that are IR transmitter and IR reveiver. Using this low-cost project one can reproduce audio from TV or other electronic devices without… Read More »
This is the light fence schematic diagram uses LDR as the light sensing. The fundamental issue with the greater part of standard light sensors is that they require exact arrangement of light bar to quiet the circuit throughout standby mode. The circuit portrayed here is sensitive to the point that it will catch a moving… Read More »
Automatic Switching-on Emergency Light The schematic diagram shown right here is the automatic switching-on emergency light circuit which is controlled using IC. The most important capabilities of this circuit are: automatic switching-on of the light on main power failure and battery charger with overcharge protection. When mains electrical power is absent, relay RL2 is in… Read More »
The above diagram is the schematic diagram of an electronic motor starter circuit. This motor starter protects singlephase motors against voltage fluctuations and overloading. Its salient function is a soft on/off electronic switch for simple operation. The transformer steps down the AC voltage from 230V to 15V. Diodes D1 and D2 rectify the AC voltage… Read More »
Here is a simple Tachometer schematic. The basis of the frequency converter circuit-current, which converts the input signal into a proportional current measured pointer device. Deflection milliammeter proportion to the frequency input signal. To install the device on input pin A car should be connected to high voltage wire and pin B – to the… Read More »
The Univibe is actually a footpedal-operated phaser or phase shifter for generating chorus and vibrato simulations for electric organ or guitar. It was introduced in the 1960s by Shin-ei, and was intended to emulate the “Doppler sound” of a Leslie speaker. Although not a really successful Leslie-simulator, the Univibe has turn out to be an… Read More »