Here is the 200W MOSFET amplifier powered based on four piece of IRFP250N, they are very cheap and easy to find in the electronic market in your area. The circuit has been assembled and tested with very good performance.
This is 500W RMS power amplifier circuit design, build based on MOSFET. The circuit is very popular in EE audio hobbyist as “LEGEND stage Master MK2”. It is a very good and powerful amplifier. It uses 12x power MOSFET IRFP240.
This is the simple and low cost pulse width modulation – PWM DC motor controller using a MOSFET. This kind connection for DC motor control is to prevent heat and minimize the power consumption. It controls the motor speed by driving the motor with short pulses. These pulses vary in duration to change the speed… Read More »
This is a small 12W audio amplifier over a load of 8 Ω, that combining the NE5534 integrated with a pair of V-MOSFET transistor output stage technology as we get excellent sound performance. MOSFET 2SK135 / 2SJ50 from Hitachi is used in this circuit. Input sensitivity of the circuit is 3V RMS maximum, the distortion factor… Read More »
This is a 2W RF amplifier circuit build with single power MOSFET LF2810A. Figure A Figure A is the schematic of the microstrip single stage RF amplifier. The amplifier is based on the M/A-Com LF2810A MOSFET. The transistor is actually a 10 watt, 28 volt part, but provides adequate gain for this application at 12… Read More »
This MOSFET Linear Amplifier has capability to deliver up to 300W for 50MHz. The circuit built based the couple of MOSFET ARF448A and ARF448B. Circuit Design:
Here the schematic diagram of 70W power amplifier with MOSFET for your audio system. There are possible alternative input stage transistors, the Toshiba 2SA970BL and 2SC2240BL, which appear to be good substitutes for the Hitachi 2SA1085E and 2SC2547E. The ‘BL’ suffix is the high gain group. Alternatives for the Sanyo 2SC2911 and 2SA1209 are the… Read More »
This is another 100 watt inverter circuit diagram. Built based on IC CD4047 and Mosfet IRF540, this inverter have ability to supply electronic device -which require 220VAC- up to 100w from 2-3A transformer from 12V lead acid battery. In the circuit diagram we can observe that 12V battery is connecter to the diode LED and… Read More »
Here the schematic diagram of 800 watt audio power amplifier with MOSFET for final amplification. This amplifier can be used for practically any application that requires high power, low noise, distortion and excellent sound. Examples would be Sub-woofer amp, FOH stage amplifier, One channel of a very high-powered surround sound amplifier etc.